User manual CANON I9100

[. . . ] Remove the protective tape. 5 Close the front cover, attach the paper rest and extend the paper output tray. Ink Tanks BCI-6C Cyan BCI-6M Magenta BCI-6BK Black BCI-6Y Yellow Protective tape 5 Lower the lock lever and press it down until it locks into place. Serial number BCI-6PC Photo Cyan BCI-6PM Photo Magenta NOTE: USB cable is not included. Write down the serial number located to the right of the print head. You will need this later to register the product. Continue with Step 6 on side two. 6 Install the Printer Driver (Windows ) ® 6 M ac in to sh 5 When the Printer Port window appears, Install the Printer Driver (Macintosh®) 7 Align the Print Head 8 Click Install. [. . . ] The software will begin identifying the printer port being used. insert the "i9100 Setup Software & User's Guide" CD-ROM. your confirmation to proceed with the installation, click Continue Installation. Before using the printer, align the print head to ensure the best quality printing. 1 Load a sheet of blank paper in the paper rest. 2 Double-click the CD-ROM icon, then the Mac OS X folder, then the Printer Driver folder. 2 Start the alignment procedure. Windows: NOTE: For Windows® XP or Windows 2000, log on to Windows as a member of the Administrators group before continuing. IMPORTANT: If your computer cannot detect a printer port, refer to the Troubleshooting chapter in the "i9100 Quick Start Guide" for instructions. 9 When the message "The software was successfully installed" appears, click Restart. 3 Double-click the i9100 180. pkg icon. For Windows XP/2000 click Start, select Control Panel, Printers and Other Hardware, then Printers and Faxes. Right-click the i9100 icon, then click Printing Preferences. NOTE: For Windows 98/Me click Start, then select Settings, Printers. Right-click the i9100 icon, then click Properties. Click the Maintenance tab, then click on the Print Head Alignment icon. When asked to start print head alignment, click OK. IMPORTANT: If you see the Found New Hardware Wizard, click Cancel. 6 When the driver installation is complete, Application folder, double-click on the software to be installed. click Finish. 7 Register your product to ensure product support. Select i9100, and click Select. 4 When the main menu appears, click Install. 9 When the software installation is complete, click OK, then Exit. b. Click the down-arrow to select Test Print. Click the Print Head Alignment icon. IMPORTANT: To ensure highest quality output, continue with Step 7 Align the Print Head. NOTE: If you are prompted to restart Windows, remove the CD-ROM, then click OK. After the computer restarts, insert the CD-ROM and continue. 3 Follow the on-screen instructions. 4 Click OK (Windows) or Send (Macintosh) when finished. Part no. QA7-2669-V01 © 2003 Canon U. S. A. , Inc. [. . . ] QA7-2669-V01 © 2003 Canon U. S. A. , Inc. Canon is a Registered Trademark of Canon Inc. [. . . ]