User manual CANON NP 6028 BROCHURE

[. . . ] These cards are collectively called memory cards in this guide. * SD stands for Secure Digital, a copyright protection system. Use of genuine Canon accessories is recommended. This product is designed to achieve excellent performance when used with genuine Canon accessories. Canon shall not be liable for any damage to this product and/or accidents such as fire, etc. , caused by the malfunction of non-genuine Canon accessories (e. g. , a leakage and/or explosion of a battery pack). Please note that this warranty does not apply to repairs arising out of the malfunction of non-genuine Canon accessories, although you may request such repairs on a chargeable basis. 1 Table of Contents Items marked with a are lists or charts that summarize camera functions or procedures. Conventions Used in this Guide . [. . . ] - Images from continuous shooting - Self-timer images (custom) - Stitch Assist mode images - Still images shot in Color Accent/Color Swap mode with the [Save Original] category set to [On] Images cannot be played back when the folder numbers are duplicated or image numbers are duplicated within folders. Please refer to the Software Starter Guide for information regarding folder structures or image types. 71 72 Playback/Erasing Please also see the Basic Camera User Guide (p. 11). Magnifying Images 1 Press the zoom lever toward will display and a magnified portion of the image will display. Images can be magnified up to a factor of approximately 10x. . Approximate Location of the Displayed Area 2 Use the , , or around the image. button to move Playback/Erasing If you press the FUNC. /SET button while in magnified display, the camera switches to image advance mode and will display. You can use the or button to advance to the next or previous image at the same level of magnification. The image advance mode is canceled when you press the FUNC. /SET button again. You can change the magnification level with the zoom lever. To Cancel the Magnified Display Press the zoom lever toward . (You can also cancel it immediately by pressing the MENU button. ) Movie frames and index playback images cannot be magnified. 73 Viewing Images in Sets of Nine (Index Playback) 1 Press the zoom lever toward Up to nine images can be viewed at once. Use the , , or button to change the image selection. . Selected Image Movie Switching between Sets of Nine Images The jump bar will display if you press the zoom lever toward while in index playback and you can switch the display between sets of nine images. Use the or button to move to the previous or next set of nine images. 26). Playback/Erasing 2 Use the or button to select an image to to rotate it. rotate and press Cycle through the 90°/270°/original orientations with each press of the FUNC. /SET button. This also can be set in the index playback mode. When images are downloaded to a computer, the orientation of images rotated by the camera will depend upon the software used to download the images. 79 Playback with Transition Effects You can select the transition effect displayed when switching between images. The displayed image darkens and the next image gradually brightens until it is displayed. Press the and the button to have the previous image display from the left button to have the next image display from the right. 1 (Play) Menu / . See Menus and Settings (p. 26). The transition effect will not display when an image is switched while the camera is reading an image from the memory card. 80 Adding Effects with the My Colors Function You can add effects to recorded images (stills only) using the My Colors function. The following selection of My Colors effects is available. For details, see p. 60. Vivid Neutral Sepia B/W Positive Film Lighter Skin Tone Darker Skin Tone Vivid Blue Vivid Green Vivid Red 1 (Play) Menu . See Menus and Settings (p. 26). Playback/Erasing 2 Use the or button to select an image and press . 3 Use the or button to select the My Colors type and press . The displayed image will reflect the My Colors effect. You can press the zoom lever toward to check the image at a higher magnification. While the image is zoomed, you can press the FUNC. /SET button to switch between the image transformed with the My Colors effect and the original nontransformed image. 81 4 Select [OK] and press . The newly saved image transformed with the My Colors effect will be the last one in the list. To continue adding effects to other images, repeat the procedures from Step 2 onward. 5 Press and select [Yes] . or [No], then press Selecting [Yes] displays the image transformed with the My Colors effect, while [No] returns you to the Play menu. [. . . ] For connection to a supply not in the U. S. A. , use an attachment plug adapter of the proper configuration for the power outlet. This battery charger is for exclusive use with Battery Pack NB-5L (1. 12 Ah). There is a danger of explosion if other battery packs are used. Copyright © 2006 Canon Inc. All rights reserved. 134 FCC Notice (Digital Camera, Model PC1176) This device complies with Part 15 of the FCC Rules. [. . . ]