User manual CANON PC330 BROCHURE

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] : Signal flow OUTPUT S-150 S-video Cable S(S1)-VIDEO VIDEO STV-250N Stereo Video Cable AUDIO L R Editing Side with arrow Commercially available DV cable Above illustration shows the connection using a S-video cable. You can also connect to the VIDEO terminal instead ( 35). 90 Turning the analog-digital converter on TAPE E + PLAY (VCR) VCR. SET UP ( 39) AV DV OUT•••OFF To turn the analog-digital converter on, open the menu and select VCR SET UP. Then select AV \ DV OUT, set it to ON and close the menu. Cautions: • For normal use, set AV \ DV OUT to OFF through the menu. If it is set to ON, you cannot input digital signals through the camcorder’s DV terminal. € When connecting to a PC equipped with a DV terminal, you may not be able to transfer converted signals to your PC, depending on the software you are using, and the specifications of your PC and its settings. 91 Editing Recording Over Existing Scenes (AV Insert Editing) E You can insert and replace images/audio on the tape of the camcorder with images/audio from other video devices connected via AV terminal or DV terminals. original video and audio will be replaced with the new video and audio. Scene to be inserted The playback tape Insert start point Insert end point Before inserting The tape in the camcorder After inserting The tape in the camcorder : Signal flow Editing OUTPUT S-150 S-video Cable S(S1)-VIDEO VIDEO STV-250N Stereo Video Cable AUDIO L R ZERO SET SEARCH MEMORY SELECT AUDIO DUB. € If you set the zero set memory at the position on the tape where you want to stop inserting, every time you return to that point, the camcorder will cancel its AV inserting and enter stop mode. Editing 94 Audio Dubbing You can add sound to the original sound on a pre-recorded tape from audio products (AUDIO IN) or with the internal or external microphone (MIC. For best results, add sound to tapes that have been recorded with this camcorder in SP mode with 12-bit sound. If there are non-recorded portions on the tape, or portions recorded in a mode other than SP mode, or with 16-bit or 12-bit, 4-channel sound, dubbing will stop. If your tape hasn’t been recorded in SP mode with 12-bit sound, we recommend dubbing your original tape onto a blank tape using the ELURA50’s analog line-in function, then dubbing audio onto the new tape. Make absolutely sure to set the audio mode of the new tape to 12-bit and the recording mode to SP. CD player) Notes: • Do not use the yellow video terminal. € The AV terminal doesn’t put out any video, so connect the S-video terminals and check your TV, or check the LCD or the viewfinder as you add new sound. Always check the new sound with the speaker. Editing To connect an external microphone: 95 E Notes: • When adding sound using the built-in microphone, make sure not to connect any cables to the MIC terminal. € To use your TV to monitor video, connect the S-video terminal ( 34) or the AV terminal (use only the video plug) to your TV. [. . . ] In order to obtain warranty service, contact the authorized Canon retail dealer from whom you purchased the DV Camcorder or call the CANON INFORMATION CENTER AT 1-800-828-4040 (which is open from 9:00 a. Have your unit serial number and your date of purchase available when you make the call to expedite service. In either case you will be directed to ship the DV Camcorder, postage prepaid, to the CUSA Center or Service Facility nearest to you. You must include a copy of the proof of purchase (bill of sale) and a complete explanation of the problem. [. . . ]