User manual CANON PC428 BROCHURE

[. . . ] ¡You can adjust the focus, without turning off the autofocus, by turning the lens’ focusing ring. Autofocus resumes as soon as you take your hand away from the ring. Using the Zooming Ring Turn the ring to the right to zoom out to the wide-angle end, and to the left to zoom in to the telephoto end. ¡Turn the ring in one large movement to operate the high speed zoom. [. . . ] Turn the ring more slowly to make fine adjustments to the zoom. Using the Other Lens Functions Auto/Manual Focus Switch To set the focus to manual, slide the focus switch to the M position. To set the focus to Auto, slide the focus switch to the AF position. Push AF Button Press the PUSH AF button during manual focusing (with the focus switch set to M) to quickly adjust the focus automatically. The camcorder will continue to focus automatically as long as you hold down the button. Release the button to return to manual focus. ND Filter Slide the ND FILTER switch to ON to use the filter. ¡Your camcorder may show displays relating to the ND Filter−refer to its instruction manual for more details. ¡When you turn the ND filter on/off, make sure that you slide the ND FILTER switch across until you hear it click into position. ¡The felt portions on the inside of the lens hood are easily damaged. Take care not to soil, chafe, or press too firmly on the felt. To ensure that you gain maximum optical performance from your lens in ultra wide-angle photography, use of the XL 1. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: −Reorient or relocate the receiving antenna. ˆIncrease the separation between the equipment and receiver. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: −Reorient or relocate the receiving antenna. ˆIncrease the separation between the equipment and receiver. ˆConnect the equipment into an outlet on a circuit different from that to which the receiver is connected. ˆConsult the dealer or an experienced radio/TV technician for help. [. . . ]