User manual CANON PC65 BROCHURE

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. [. . . ] When you turn the program selector to Av the current F (aperture) number is shown in the display. Select your desired F number by turning the Av/Tv CTRL. You can choose F numbers of between F1. 8 and F32. For smaller aperture, select a higher value for the F number. Notes : • The Tv and Av values are reset if you turn the power off or turn the program selector to another setting. If you turn the standby lever to LOCK, the camera remembers your chosen values. • You are able to press and hold the Av/Tv CTRL (EXP wheel) after setting the Av or Tv to lock/adjust the exposure (p. • When shooting using the Av program, if the F number display flashes the camera has not been able to set the exposure correctly. In such a case, change the setting so that the display stops flashing and lights up continuously. Using the Full Range of Features Negative-Positive Conversion Records a color negative of the image. White appears as black, yellow appears as blue, green appears as red, etc. Also converts a negative image to an ordinary positive one. F AD E Using the Full Range of Features W I N DOW WI PE 4. When you reach your chosen fader stop pressing/release the button and your chosen fader will be put into the memory. • The camera automatically exits the fader option screen after a few seconds. • The name of your chosen fader is shown in the display. 5. Start or stop recording. • The recording will start or stop with the selected fade. • The display will start flashing again. If you wish to use the fade again, press the D. FADER button again. • You can turn the selected fade effect off before you use it by pressing the D. FADER button again. 41 E Notes: • You are unable to use any of the digital faders when the camera is set as follows: - Easy Recording program. • You cannot use the mosaic fade or the window wipe if: - You have turned on the digital zoom or 16:9 effect at the menu. - The recording program is set to Auto, Sand and Snow or Spotlight (when the camera is set to PRO. SCAN movie mode). When you enter the fader options screen M. FADE and WINDOW are shown in purple and cannot be selected. If you have already activated one of these faders, and then change the camera setting to one of the above, the fader name flashes purple for about four seconds and then disappears from the display (it is deactivated). 16:9 (Widescreen TV recording) Produces images in the 16:9 format for playback on widescreen TVs. Using the Full Range of Features 1. [. . . ] Refer to page 11. TAPE END 0 sec 1 0 sec THE TAPE IS SET FOR ERASURE PREVENTION Appears when you press the 2 (record) button if the DV cable is not connected properly (p. CONDENSATION HAS BEEN DETECTED Appears as a warning to protect the tape and also when condensation is detected. Remove the tape as soon as possible after the camera has displayed the caution. COPYR IGHT PROTECTE D DUBBI NG REST R I CTED When you start recording, the camera counts from 0SEC to 10SEC. [. . . ]