User manual CANON XF305

[. . . ] DIE-0356-000B HD Camcorder Instruction Manual PAL Important Usage Instructions WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. COPYRIGHT WARNING: Unauthorized recording of copyrighted materials may infringe on the rights of copyright owners and be contrary to copyright laws. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK AND TO REDUCE ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. [. . . ] (Default: 0) 114 Custom Picture Settings Customization 4 Knee Slope Knee Point Output Input Output Input Sharpness Sets the sharpness of the output and recording signal. This setting can be adjusted from -10 to 50. (Default: 0) [H Detail Freq. ]: Sets the center frequency of horizontal sharpness. Setting higher values increases the frequency, which, in turn, increases the sharpness. This setting can be adjusted from -8 to 8. (Default: 0) [Coring]: Reduces noise artifacts caused by high sharpness levels. Higher values prevent sharpness from being applied to minute details, resulting in less noise. This setting can be adjusted from -30 to 50. (Default: 0) [D-Ofst]: You can use [D-Ofst], [D-Curve] and [D-Depth] to adjust the coring level based on brightness. [D-Ofst] sets the coring level of the minimum brightness level. This setting can be adjusted from 0 to 50. (Default: 0) [D-Curve]: Sets the curve of the coring adjustment. This curve is the change from [Level] to [D-Ofst]. This setting can be adjusted from 0 to 8. (Default: 0) [D-Depth]: Sets a multiplier to [D-Ofst] that determines the coring level adjustment based on brightness. Positive values raise the coring level in dark areas and negative values lower the level. This setting can be adjusted from -4 to 4. (Default: 0) [HV Detail Bal. ]: Adjusts the ratio between horizontal and vertical detail. Higher values emphasize vertical detail while lower values emphasize horizontal detail. This setting can be adjusted from -8 to 8. (Default: 0) [Limit]: Restricts how much sharpness is applied. This setting can be adjusted from -50 to 50. [. . . ] b Bit rate 50 Mbps Usage time Recording (maximum) Recording (typical)* Playback 35 Mbps Recording (maximum) Recording (typical)* Playback 25 Mbps Recording (maximum) Recording (typical)* Playback Viewfinder LCD screen Viewfinder LCD screen LCD screen Viewfinder LCD screen Viewfinder LCD screen LCD screen Viewfinder LCD screen Viewfinder LCD screen LCD screen BP-955 260 min. 445 min. 191 8 Additional Information Optional Accessories c Bit rate 50 Mbps Usage time Recording (maximum) Recording (typical)* Playback 35 Mbps Recording (maximum) Recording (typical)* Playback 25 Mbps Recording (maximum) Recording (typical)* Playback Viewfinder LCD screen Viewfinder LCD screen LCD screen Viewfinder LCD screen Viewfinder LCD screen LCD screen Viewfinder LCD screen Viewfinder LCD screen LCD screen BP-955 295 min. 535 min. * Approximate times for recording with repeated operations such as start/stop, zooming, and power on/off. CB-920 Car Battery Adapter Use the car battery adapter to power the camcorder or charge battery packs on the go. The car battery adapter plugs into your car's cigarette lighter socket and runs off a 12-24V DC negative ground battery. TA-100 Tripod Adapter The TA-100 allows you to quickly mount/unmount the camcorder on/from a tripod. SBR-1000 Shooting Brace Using the SBR-1000 for additional support of the camcorder with the neck strap will significantly lighten the load of the camcoder's weight while shooting. 192 Optional Accessories Additional Information 8 WA-H82 Wide Attachment The wide attachment decreases the camcorder's focal length by a factor of 0. 8, allowing you to make recordings with a wider angle of view. Remote Controller When the ZR-2000 or ZR-1000 is connected to the camcorder's REMOTE terminal, it is possible to control functions such as the start and stop of recording, the zoom and the focus functions while reviewing the picture on an external monitor without touching the camcorder. [. . . ]