User manual CANTON DIGITAL MOVIE DM 70

[. . . ] To protect the DM system amplifiers from overheating they must be located at a minimum distance of 5 cm from walls and furniture. Avoid any build-up of heat and never cover your DM system with curtains, tablecloths etc. The DM 70 has magnetic shielding and can therefore be positioned next to your television set. Do not position your DM system near any heat source or open flames (e. [. . . ] Be careful to ensure that it is inserted correctly according to the polarity markings (+/-). In order to avoid unloading, the battery should only be touched on the , , +" pole. When all the devices are connected and the system is plugged in at the mains the Canton DM system is in standby mode. press any button to activate the remote control. If the remote control is not used for more than 30 seconds it returns to standby mode and can be reactivated by pressing any button. The DM system can be switched on or returned to standby mode by pressing . If the red power light (LED) is flashing this means that there is no wireless connection between the remote control and the system. By pressing the volume of the DM system in the main menu can be adjusted in 100 stages from 0 . Only 11 stages will be displayed at any time. The following lights will come on: - one volume LED - one playback mode LED - one or two decoder mode LEDs Press again to turn the DM system off. You can switch the inputs of the DM system directly using the buttons , , sat", , , dvd", , , tv" and , , aux". Use to select whether the sound reproduction should be in stereo or surround mode. Note: In order to accommodate the different recording philosophies unique to music recordings we have implemented two surround modes. Use , , surround 2" predominantly in the case of poor speech intelligibility (for example, when the speech reproduction seems unusually dull and unclear). Once your DM system has been successfully connected you need to adjust the individual components to suit the enviroment. To adjust the DM system, turn it on and press the button for about 3 seconds. the LED , , Set" will start to flash. You can then use the relevant buttons (spk level, spk delay, bass exp. The values within each function can be adjusted up or down using the ­setup+ buttons. To leave the Setup press one of the input buttons, press the button again or wait until the remote control goes into standby after approx. Speaker Delay (Distance) First measure the distance between the individual component parts of the DM system and your preferred listening position. Press the function (distance of loudspeaker) as described button repeatedly until you have selected your The six LEDs on the left at the bottom will show which loudspeaker has been selected. [. . . ] You have too much lower bass The DM is very close to the wall or in the corner 2. Your bass levels are incorrectly set You have a delay between the image signal of your flat screen and the audio signal The signal sounds distorted The signal processing of the flat screen takes longer than that of the DM system The level of the system is set too high 40 To ensure that you enjoy your Canton loudspeakers for a very long time please note the following care and maintenance instructions: Do not expose the cabinet of the loudspeaker to direct sunlight. Avoid extreme changes in temperature and protect your loudspeaker from moisture. do not use abrasive or alcohol-based cleaning agents. [. . . ]