User manual CANTON INWALL

[. . . ] These items permit installation of the InWall systems in walls or ceilings of from 6 mm to 35 mm thickness. In walls thicker than 35 mm, you will require longer screws. For clean installation in solid masonry walls, we recommend the use of a special accessory installation frame which neatly covers the installation opening. This installation frame may be ordered through Canton Customer Service. [. . . ] As a rule, danger to loudspeakers is more likely to be caused by lowpowered amplifiers since, when attempting to achieve greater sound pressure by turning up the volume and tone controls, they are overdriven and go into so-called , , clipping", creating overtones which can destroy speaker tweeters in particular. In this case, please turn down the volume control on your amplifier. After cooling off, the speakers will again perform normally. Use the enclosed installation template to ascertain the exact size of the wall cutout. The outer edge of the template indicates the size of the cover trim. Now hollow out an appropriate installation opening in the wall/ ceiling. When laying loudspeaker cable from amplifier to installation point, be sure that the cable ends protrude about 30 cm beyond the wall cutout. Before fastening the speaker cable to the screw clamps of the InWall systems, you must first split the two-conductor cable and strip off about 1. 5 cm of insulation from the cable ends. Now connect the marked cable (+) with the red screw clamp on the crossover network, the second cable (-) with the black screw clamp. Make sure that the red mounting tabs (6 per InWall system) do not stick out (photo above), but are in a position facing the inside (photo underneath) so that the InWall system will fit in the installation opening. Now the speaker system can be inserted into the wall cutout and can be secured using the silver screws. Important: To prevent damage to the mounting tabs, do not twist the screws too tightly. After that you can insert the grille into the InWall system. In order to make the installation under problematic conditions easier it is possible to separate the baffle of the InWall system from the frame. Make sure that the red mounting tabs (6 per InWall system) are in a position facing the inside (photo underneath) so that the InWall system will fit in the installation opening. After that the frame can be inserted into the wall cutout and can be secured using the silver screws. Important: To prevent damage to the mounting tabs, do not twist the screws too tightly. Before fastening the speaker cable to the screw clamps of the InWall systems, you must first split the two-conductor cable and strip off about 1. 5 cm of insulation from the cable ends. Now connect the marked cable (+) with the red screw clamp on the crossover network, the second cable (-) with the black screw clamp. Once this contact is established, the speaker system can be screwed into the installation frame using the six black screws. [. . . ] Augmenting speakers for left and right channels, it reproduces the center channel. So it is best positioned directly above or below the TV set. You will find a large selection of Center Speakers for expanding stereo setups into Home Theater systems in the current Canton loudspeaker range. Please note: If InWall systems are to be used near a TV set, the speakers should be positioned at a distance of about 1. [. . . ]