User manual CARDO SCALA-500

[. . . ] Turn on your phone and make sure its Bluetooth function is activated. With the headset turned off, press and hold the Control Button for ten seconds until the red and blue Status Lights begin flashing. Search for Bluetooth devices on your phone by following the phone's instructions. After a few seconds the phone will list the scala-rider TeamSet as a discovered device. [. . . ] If the synchronization has failed, the steady red Status light on the Passenger unit will turn off without switching to steady blue for a few seconds, and you must repeat the synchronization procedure. 6 ATTACHING THE SCALA-RIDER UNITS TO YOUR HELMETS Perform this procedure for both the driver and passenger helmets. Use the enclosed Allen Wrench to loosen the two screws on the Back Plate. Slide the Back Plate between the internal padding and the external shell of the helmet. (If the external shell is too thick, use the supplied plastic Extension Pad by loosening the screws and fitting the extention pad between the Back Plate and the main body of the clamp). Adjust the clamp's location so that the microphone is located in front of your mouth, and then tighten the screws. Attach the speakers to the Velcro inside your helmet opposite your ears (short speaker cord for left ear & long speaker cord for right ear), or use the supplied Velcro pad. Allen Wrench Back Plate CORRECT INCORRECT NOTE: The microphone must be positioned vertically and not horizontally. 7 4. Slide the headset downwards along the sliding panel until a clicking sound indicates that the headset is locked in place. REMOVING THE HEADSET FROM THE HELMET Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you store your headset in the enclosed carrying pouch when not in use. Press here to remove 8 DRIVER'S UNIT FUNCTIONS DESIRED RESULT: G E N E R REQUIRED ACTION: A L F U N C T I O N S Turn on the headset Turn off the headset Increase the volume Decrease the volume P H O N Press the Control Button steadily for at least 6 seconds Press the Control Button steadily for at least 3 seconds Short press the Volume Up Button. Short press the Volume Down Button. E F U N C T I O N S Answer a call Reject a call Terminate a call Voice Dial Redial Enable/Disable voice command feature Short press the Control Button or speak loudly any word of your choice. Short press the Intercom Button or remain silent for 15 seconds. Your phone supports only the Bluetooth headset profile and not the handsfree profile. Therefore you must use the Control button to answer or terminate calls. Make sure that you speak the word loudly after prompting 2. Make sure that the VC feature is activated (see Driver's Unit Functions, page 9) 4. The VC feature works well while driving up to 70 km/h or 44 mph with a 3/4 helmet and up to 120 km/h or 75 mph with a closed full faced helmet. High-end helmets may get better results. Make sure that the call list on your phone is not empty. The Redial feature works only with mobile phones that also support the Bluetooth handsfree profile. Check whether your phone supports this profile. 13 Battery does not provide at least five hours of talk time I'm trying to reject incoming calls by remaining silent, but the phone continues to ring. Red Status Light does not light steady when charger is connected. I hear crackling noises Sound deteriorates when the phone is in my back pocket. 1. Make sure your scala-rider headset is fully charged. [. . . ] Suggestion: Move the phone to your breast 14 The party I am speaking to complains about insufficient audio quality pocket or at least to a front pocket on the same side you wear your headset. Close helmet cover under high speed conditions. Make sure the microphone is in front of your mouth. The microphone should be positioned vertically as described on page 7. Intercom-Related Problems (driver/passenger) Cannot initiate conversation 1. [. . . ]