User manual CARLSBRO SLAMMER 2

[. . . ] DE55 2DS England WORLD CLASS PA & AMPLIFICATION SYSTEMS SINCE 1959 TECHNICAL SPECIFICATIONS Voltage Requirement (Factory Preset) 230V 207-253V 50-60Hz AC 115V 104-125V 50-60Hz AC Power Consumption 990VA Subwoofer Power Output 300W rms Frequency Response 35Hz-250Hz Satellite Power Output @ 4 2 x 150W rms Frequency Response 20Hz-20KHz Height 700mm Width 320mm Depth 450mm Weight (Approx) 31. 6Kgs OPTIONAL EXTRAS Many approved Carlsbro accessories are available to help you get the most out of your Slammer II active subwoofer, such as Speaker stands, cables, mixing desks and many more items. For more information, talk to your local Carlsbro retailer of visit the website at WWW. CARLSBRO. COM for the full range of Carlsbro products. . Carlsbro Electronics Limited constantly seek ways to enhance our products, and improvements take place continually. [. . . ] The wiring convention is as follows: Balanced XLR Pin 1 = Screen (Ground) Pin 2 = In Phase (Hot) Pin 3 = Anti-Phase (Cold) Unbalanced XLR Pin 1 = Screen (Ground) Pin 2 = Signal (Hot) Pin 3 = Link to Pin 1 Balanced Jack Sleeve = Screen (Ground) Ring = Anti-Phase (Cold) Tip = In Phase (Hot) Unbalanced Jack Sleeve = Screen (Ground) Tip = Signal 3. Phono Inputs: These 2 connections are designed to take a stereo line level signal from a cd player, Laptop PC, MP3 player etc. The Red connection is the right channel input and the white connection is for the left channel. The wiring convention is as follows: Ring = Screen (Ground) Pin = Signal 4. Right XLR/Jack Inputs: This is identical to the left `combi' socket input, but for the right channel. Right Link Output: This is identical to the left link output, but for the right channel. Left Level: This controls the output level (volume) for the left Satellite speaker output. For maximum output turn this control clockwise until the `Limit' LED intermittently illuminates. The limit warning should illuminate only on the peaks of the signal, not continuously. Left Limit LED: This LED illuminates to indicate that the input signal to the amplifier is at its maximum allowable level and the signal is being limited to reduce distortion. 8. 120Hz Low Cut: This switch activates a 120Hz active high pass filter that removes all low bass signals from both left and right Satellite speaker outputs. 9. Right Level: This is identical to the left level control, but for the right channel. Right Limit LED: This is identical to the left Limit LED, but for the right channel. Subwoofer Level: This control sets the output level for the internal subwoofer. [. . . ] Should the mains fuse need replacing, it is located below the mains input. Always replace the fuse with type and rating printed on the rear panel of your Slammer II. [. . . ]