User manual CARRIER 2K19H81

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CARRIER 2K19H81. We hope that this CARRIER 2K19H81 user guide will be useful to you.

Lastmanuals help download the user guide CARRIER 2K19H81.


Mode d'emploi CARRIER 2K19H81
Download
Manual abstract: user guide CARRIER 2K19H81

Detailed instructions for use are in the User's Guide.

[. . . ] In split systems this relay turns off the contactor coil of the compressor interrupting pump operation. Removing the water from the drain pan is done via a float incorporated in the level regulator . [. . . ] ) in a horizontal position and on a stable support taking into consideration the periodical maintenance operations. Never pierce the side or bottom part of the drain pan. Fix the level controller with the clip WARNING: The level controller must be mounted in a perfectly horizontal position and the filter must never contact the electrodes. Switch to super-quiet speed (whisper mode), or to high speed if the elevation and the horizontal tract planned exceeds the limits allowed by the whisper mode using the switch ¹ indicated in figure. ⷠRemove the pump cover and connect the transparent PVC tube to its special attachments. Fix the connectors to the power supply cable . The ways of connecting the pump to the electronic control vary depending on whether the CZM (Zone Manager) kit is installed or not: No CZM kit installed · Connect pump power supply terminal block terminals "C" and "Nc" to connector J2 of the logic board, using the cable with a 9 pole connector (see figure and wiring diagram). Clip Double-sided adhesive strip Field supplied Fixing clamp Flexible PVC tube µ Tube conduit ¸ Level controller section ¹ Switch Supply power connector Level controller connector Super-quiet speed (whisper) High speed Switch to super-quiet speed (whisper mode), or to high speed if the elevation and the horizontal tract planned exceeds the limits allowed by the whisper mode using the switch ¹ indicated in figure. ⷠRemove the pump cover and connect the transparent PVC tube to its special attachments. Fix the connectors to the power supply cable . The ways of connecting the pump to the electronic control vary depending on whether the CZM (Zone Manager) kit is installed or not: The CZM kit is installed · Connect pump power supply terminal block terminals "C" and "Nc" to connector J3 of the auxiliaty board, using the cable with a 2 pole connector (see figure and wiring diagram). Clip Double-sided adhesive strip Field supplied Fixing clamp Flexible PVC tube µ Tube conduit ¸ Level controller section ¹ Switch Supply power connector Level controller connector Super-quiet speed (whisper) High speed Installing the pump inside the unit · Fix the pump using the 2 adhesive strips . [. . . ] Check the filter on the level controller every six months. Check that the level controller is replaced in the correct position. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CARRIER 2K19H81

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CARRIER 2K19H81 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag