User manual CARRIER 50QKAUTR

[. . . ] 1 Connect the small plug to the appliance (1) and the mains plug to the wall socket (2). English , , The charging light pulsates white to indicate that the appliance is charging. When the batteries are fully charged, the charging light lights up white continuously for 20 minutes and then goes out. 5 Batteries low or empty -- When the batteries are almost empty, the charging light starts to flash red. [. . . ] The appliance works best when you move it over your skin without excessive pressure. If the overheat protection is activated, the appliance switches off automatically and the charging light and the speed lights flash red for 30 seconds. You can deactivate the overheat protection by letting the appliance cool down and then switch it on again. Note: If the charging light flashes red again, the appliance has not yet cooled down completely. Overload protection If you press the epilating head onto your skin too hard or when the epilating discs of the epilating head get blocked (e. By clothes), the appliance switches off automatically and the speed lights flash red for 5 seconds. 1 Turn the epilating discs with your thumb until you can remove whatever blocks the epilating discs. Using the precision epilator Inserting/changing the batteries 1 Remove the lid of the battery compartment by pressing the snap hooks. Note: Make sure the + and - poles of the batteries point in the direction indicated at the bottom of the battery compartment. Note: New batteries have an operating time of up to 40 minutes. 3 To close the battery compartment, first insert the bottom part of the lid into the rim of the compartment (1) and then press the top part of the lid home until it locks with a snap (2). 2 Switch on the light by sliding the on/off button. 3 Remove any hairs outside the marked shape. Always pull out the hair in the direction of hair growth. Replacing the batteries 1 Open the battery and light compartment by turning the bottom anticlockwise with a coin. Keep the button batteries out of the reach of children and pets. button batteries present a potential choking hazard. English 3 Insert the new button batteries with the negative side pointing forward into the battery and light compartment. 13 Note:The Smart Tweezers work on three alkaline button batteries, type L736H or AG3 (dia. 4 Screw the bottom back onto the battery and light compartment by turning it clockwise with a coin. Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. Never rinse it under the tap or immerse it in water. [. . . ] 1 To activate the travel lock, press and hold the on/off button for 3 seconds until the speed lights flash white 2 times. , , The epilator starts running and stops immediately when the travel lock activates. 16 English 2 To deactivate the travel lock, press and hold the on/off button for 3 seconds until the speed lights flash white 2 times. Note:You can also insert the appliance plug into the inlet socket and the adapter into a wall socket to deactivate the travel lock. [. . . ]