User manual CARRIER 51DPAAUT

[. . . ] Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e. [. . . ] The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special non-abrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. A few seconds after the hob is connected to the power level, or towards the left to decrease the power level. The min/med/max buttons can also be pressed directly to select the pre-set power levels: min (1) / med (8) / max (16), and to switch off the plate (see below). gB electricity supply , a buzzer will sound. Types of noise during normal hob operation: • Buzz: due to the vibration of the metallic parts that make up the induction element and the pot; it is generated by the electromagnetic field required for heating and increases as the power of the induction element increases. € Soft whistle: heard when the pot placed on the heating zone is empty; the noise disappears once food or water is placed into the pot. gB electricity supply , a buzzer will sound. € Loud whistle: heard when two induction elements of the same group function simultaneously at maximum power and/or when the booster function is set on the larger element while the other is auto-adjusted. Noise is reduced by decreasing the power level of the autoadjusted induction element; pot bottom layers made of different kinds of materials are among the main causes of this noise. The indicator light corresponding to the selected zone will start flashing. Confirm by pressing the Control panel lock When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. The timer begins counting down immediately. button or automatic selection occurs after 10 seconds. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed hotplates, press the button repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. [. . . ] Particles may ignite inside the oven as a result of the combustion process. There is no cause for concern: this process is both normal and hazardfree. Before initiating the PYROLYTIC CYCLE: • Remove large or coarse food residues from the inside of the oven using a damp sponge. € Do not place tea towels or pot holders over the oven handle. [. . . ]