User manual CARRIER 51DPASEL

[. . . ] 4 POWER indicator provides a visual display for the current heat level. 5 ON/OFF button switches the appliance on and off. 6 ON/OFF indicator light shows whether the appliance is on or off. 7 PROGRAMME TIMER* button controls the cooking programme times (see Start-up and use). [. . . ] Types of noise during normal hob operation: • Buzz: due to the vibration of the metallic parts that make up the induction element and the pot; it is generated by the electromagnetic field required for heating and increases as the power of the induction element increases. € Soft whistle: heard when the pot placed on the heating zone is empty; the noise disappears once food or water is placed into the pot. • Press and hold the + - button for approximately 2 electricity supply , a buzzer will sound. € Loud whistle: heard when two induction elements of the same group function simultaneously at maximum power and/or when the booster function is set on the larger element while the other is auto-adjusted. Noise is reduced by decreasing the power level of the autoadjusted induction element; pot bottom layers made of different kinds of materials are among the main causes of this noise. € Fan noise: a fan is necessary to ensure the hob functions correctly and to safeguard the electronic unit from possible overheating. The fan functions at maximum power when the large induction element is at maximum power or when the booster function is on; in all other cases, it works at average power depending on the temperature detected. Furthermore, the fan may continue to work even after switching the hob off, if the temperature detected is high. The types of noise listed above are due to induction technology and are not necessarily operational faults. Seconds: the cooking zone will immediately begin operating at its maximum power level (16). € Press and hold the button for approximately 2 seconds: the cooking zone will operate at power level 2 (slow cooking function). The timer begins counting down immediately. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed hotplates, press the button repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. Use the button repeatedly until the duration you buttons to set the new duration. Switching off the hob Press the button to switch off the appliance - do not rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. [. . . ] There is no cause for concern: this process is both normal and hazardfree. Before initiating the PYROLYTIC CYCLE: • Remove large or coarse food residues from the inside of the oven using a damp sponge. € Do not place tea towels or pot holders over the oven handle. € Turn the SELECTOR knob to the “0” position. [. . . ]