User manual CARVER 2565 SANTA CRUZ

[. . . ] Fit the appropriate plug according to the instructions in paragraph "Fitting a plug". With alternative plugs a 5 amp fuse must be fitted either in the plug or adaptor or at the main fuse box. APPLIANCES WITHOUT FITTED PLUG FITTING A PLUG - IMPORTANT The wires in the mains lead are coloured in accordance with the following code: GREEN & YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE As the colours in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured GREEN & YELLOW must be connected to the terminal in the plug which is marked with the letter `E' or by the earth symbol or coloured green or green and yellow. Must be connected to the terminal which is marked with the letter `N' or coloured black. [. . . ] - Do not allow the supply cable to hang down within reach of children. - The supply cable must never be close to or in contact with the hot parts of your appliance or any other source of heat and should be kept away from sharp edges. - For your own safety, use only the Moulinex accessories and spare parts that are suitable for your appliance. Wash all the accessories and dry them carefully, at once. Using your appliance for the first time Assembling the mincing head 1a - Take the body (A1) by the feed tube, holding Insert the feed screw (A2) (long shaft first) into the body (A1). 1b - Fit the cutter (A3) onto the short shaft with the cutting edges facing outwards. 1c - Fit the chosen screen (A4a or A4b) on the cutter (A3), locating the two lugs in the corresponding notches in the body (A1). 1d - Screw the nut (A5) home on the body (A1) without locking it. The shaft should have no play, neither should it be able to turn on its own. Otherwise, repeat the assembly procedure. Fitting the mincing head on the appliance 2a - Facing the motor unit, which should be disconnected, insert the mincer head with the feed tube inclined to the right. - Screw the nut (A5) home on the body (A1) without locking. - Fit the assembled mincer head on the motor unit as shown in 2A. You will obtain the best results with a slightly soft dough. - Choose the shape by lining up the arrow with the chosen shape. - Keep feeding dough until you have obtained the desired number of biscuits. - When all the sausage meat has been used, stop the appliance, pull the remaining sausage skin off the filler tube and tie a knot. - Set the length of your sausages by pinching and twisting the skin at the desired intervals. Assembly 7a - Facing the motor unit (H), which should be This accessory, which can be fitted on the mincer head (A), enables you to make any kind of sausage to your personal taste. Assembly - Insert the feed screw (A2) in the body (A1) of the mincer head (A). - Place the filler tube (K) in position, followed by the nut (A5), which must be firmly tightened. - Fit the assembled mincer head on the motor unit as shown in 2A. [. . . ] - Place the food in the feed tube of the body (L1) and press down with the pusher (L2). - Never push with the fingers or any other implement. - Do not insert your fingers in the drum with the appliance running. - Press the release button (E) and turn the assembly (mincer head (A) + hopper tray (B) or vegetable cutter (L)) clockwise to release it from the motor unit (H). [. . . ]