User manual CARVIN F1200

[. . . ] The receiver features true UHF diversity reception. Two antennas feed two completely independent RF receivers on the same frequency. Automatic logic circuitry continuously compares and selects the superior signal to provide better sound quality and reduce the possibility of interference and dropouts. Both the transmitter and receiver have 16 user selectable channels. [. . . ] Please allow several days for the rest of your order to arrive before inquiring. RECORD THE SERIAL NUMBER on the enclosed warranty card or below on this manual for your records. Keep your portion of the card and return the portion with your name and comments to us. HANDHELD MIC TRANSMITTER F1200 Polar Pattern RF Power Output Spurious Emissions Dynamic Range Battery Current Consumption Battery Life Dimensions Net Wt (no battery) Accessory Included Warranty Unidirectional 3 mW Under federal regulations >100 dB AA 1. 5v alkaline qty 2 30 mA typical Approx. 25 hours 9. 50" long, 2. 10" dia. 12. 7 oz (360 grams) mic clip 90 days Net Weight Accessories Warranty For your records, you may wish to record the following information. Serial No. _____________________ Invoice Date_______________ c 12340 World Trade Drive, San Diego, CA 92128 USM16 1209 USM16-KIT INSTALLATION PROCEDURE: FOLLOW STEPS (A) THROUGH (E). LOOSEN AND REMOVE THESE TWO SCREWS KEEP FOR STEP (C) SLIDE THIS TAB INTO THE CONNECTOR ON CIRCUIT BOARD A B C D ANTENNA 1 SECURE CIRCUIT BOARD WITH SCREWS FROM (A) CONNECT THIS WIRE TO THE INTERNAL CONNECTOR ON YOUR CARVIN MIXER ANTENNA 2 (USE BOTH ANTENNAS AT ALL TIMES) E MOUNT THE UNIT(S) AND BRACKET TO YOUR CARVIN MIXER WITH SUPPLIED SCREWS FRONT PANEL CONTROLS TWO USM16 RECEIVERS MOUNTED WITH THE REQUIRED USM16-KIT LARGE CONSOLES CAN ACCEPT UP TO TO 4 RECEIVERS (2 USM16-KITs) 5 1 2 3 4 5 USM16 RECEIVER FRONT PANEL FEATURES 1. CHANNEL SELECTOR Use a small screwdriver to select your desired channel. The mic or belt-pack transmitter must be set to the same channel. RF LEVEL LED The RF level is displayed by an LED which allows you to estimate the RF signal strength. AF LEVEL LED The AF LED indicates the strength of the audio signal. VOLUME/OUTPUT CONTROL Adjusts the output audio level to the mixer. If you do not have a copy of your original invoice, contact our accounting department at (800) 854-2235 to obtain a copy. If your unit is out of warranty, you will be charged the current FLAT RATE for parts and labor to bring your unit up to factory specifications. USMBP TRANSMITTER Sensitivity fine gain settings GAIN Fig. A UX-HM2 HEAD MIC Push and slide transmitter up Fig. F Set to 0 for instruments -20 -6 0 Push and slide transmitter up Set to -20 for mics Fig. D Top View Push and slide transmitter up Push and slide transmitter up Fig. C Green Power Indicator Channel Selector Push the round button to release the cable Transmitter ON/OFF switch USM16-MC HAND HELD MIC Fig. G Removable Battery dock Remove cap to turn ON and select channel USM16-BP BELT-PACK TRANSMITTER 1. A metal belt clip case protects the transmitter and features a heavy-duty clip. To access the rear controls, push the two side release buttons on the belt clip. Slide the transmitter up to reveal the rear AF Gain control. Push the two side release buttons on the belt clip. [. . . ] Use a small flat-head screwdriver to change the channel. The mini XLR input jack will connect a Lavaliere mic, headset mic, or instrument cable to the transmitter. Line up the notches on the side of the jack and plug. Push in until the cable locks into the jack. [. . . ]