User manual CARVIN PWS2001

[. . . ] This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. LIMITED WARRANTY Your Carvin product is guaranteed against failure for ONE YEAR unless otherwise stated. Vacuum tubes are guaranteed for 90 days. Carvin will service and supply all parts at no charge to the customer providing the unit is under warranty. Shipping costs are the responsibility of the customer. [. . . ] Use one set of threaded holes or the other; do not attempt to bend the antenna rods. (The optional accessory PWS-RMA rack-mount antenna kit brings antenna inputs to the front of the receiver. ) POWER CONNECTIONS Connect the included AD1205A AC adapter to the DC power input on TRANSMITTER OVERALL SYSTEM PWS-PAK UNIPAKTM the back of the Operating Freq. VHF high band, 169 MHz to 216 MHz Frequency Stability ±0. 005%, single-frequency crystal-controlled Modulation Mode FM Max Deviation ±30 kHz, traveling freq. ±15 kHz Operating Range 200' minimum Operating Temp 40° F (4° C) to 110° F (43° C) Freq. Response 100 Hz to 15 kHz RF Power Output Spurious Emissions Dynamic Range Input Connections Battery Current Consumption Battery Life Dimensions Net Wt (no battery) Accessories Included Polar Pattern RF Power Output Spurious Emissions Dynamic Range Microphone Element PWS-DYM Battery Current Consumption Battery Life Dimensions Net Wt (no battery) Accessory Included 50 mW max Under federal regulations 90 dB High impedance, low imp, bias 9V (NEDA type 1604) alkaline 30 mA typical Approx. 15 hours in "H" position Approx. 20 hours in "L" position 2. 56" W x 4. 33" H x 1. 00" D 2. 8 oz (78 grams) Hi-Z input cable Unidirectional 50 mW max Under federal regulations 90 dB Audio-Technica dynamic 9V (NEDA type 1604) alkaline 30 mA typical Approx. 15 hours in "H" position Approx. 20 hours in "L" position 9. 50" long, 2. 10" dia. 12. 7 oz (360 grams) Stand clamp INSTALLATION AND OPERATION This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This device complies with INDUSTRY CANADA R. S. S. 210, en conformite avec IC: RSS´ 210/CNR210. Operation is subject to the following conditions: 1) This device may not cause harmful interference and 2) this device must accept any interference received, including interference which may cause undesired operation. Electrical shock can result from removal of the receiver cover. Refer servicing to qualified service personnel. The circuits inside the receiver and transmitter have been precisely adjusted for optimum performance and compliance with federal regulations. Do not attempt to open the receiver or transmitter. To do so will void the warranty, and may cause improper operation. RECEIVER Receiving System Image Rejection Signal-to-noise THD Sensitivity Audio Output Unbalanced Balanced Output Conn. When the indicator becomes very dim or goes out, there is little life left in the battery. Replace it at once for continued operation af the transmitter. BATTERY-SAVE SWITCH All transmitters feature battery-save switches (Fig. As supplied, the switch is set in the "H" (high) position for maximum range. [. . . ] The transmitter and receiver should be as close together as conveniently possible. The receiver antenna should be in the open and away from any metal. If in a rack, have the unit on top or angle antennas outward away from the metal rack. A receiver cannot receive signals from two transmitters at the same time. [. . . ]