User manual CARVIN SRS65A

[. . . ] The SRS6. 5A contains a built-in power amp. 3) DISTORTION from power amps will destroy drivers much faster than clean power. 4) WATER, MOISTURE, and DUST are harmful to drivers causing failure which is not covered under warranty. WARRANTY CARVIN loudspeakers are covered by a ONE year limited warranty unless otherwise stated. [. . . ] A Contour switch is featured to replicate your normal home stereo speaker system (1. 5dB low freq. cut) This is a very useful feature during mixdown. The front ported design ensures that you can place the SRS monitors anywhere in the room without unwanted low frequency side affects, which is a problem with rear ported enclosures. FIG. 2 SRS6. 5A ACTIVE POWERED Active Biamp: Low 70w RMS, High 30w RMS Amp Response: 20 to 20 k Hz, THD . 03% Enclosure Response: 50 to 20 k Hz, ± 3 dB Inputs SRS6. 5A: Bal. XLR, 12dB attenuation pad, 90-250VAC, 50-60 Hz, LED power indicator Woofer Enclosure Type: Front Ported Box Protective Coating: Black DuratexTM SRS6. 5A: 9. 25"W x 11. 75"D x 14. 75"H, 23 lbs. RECEIVING INSPECTION INSPECT YOUR SPEAKER FOR ANY DAMAGE which may have occurred during shipping. If any damage is found, please notify the shipping company & CARVIN. SAVE THE CARTON & ALL PACKING MATERIALS. In the event you have to re-ship your unit, always use the original carton and packing material. This will provide the best possible protection during shipment. CARVIN and the shipping company are not liable for any damage caused by improper packing. It will be required for warranty service if needed in the future. If you find items missing, they may have been shipped separately. Please allow several days for the rest of your order to arrive before inquiring. RECORD THE SERIAL NUMBER on the enclosed warranty card or below on this manual for your records. Keep your portion of the card and return the portion with your name and comments to us. SRS6. 5 PASSIVE Inputs SRS6. 5: Gold 5-way binding posts Enclosure Response: 50 Hz to 20 kHz, ± 3 dB Sensitivity: 92. 5 dB SPL, 1 Watt @ 1 meter Power Handling: 125w continuous Recommended Amp: 50 to 150 watts Nominal Impedance: 8 SRS6. 5: 9. 25"W x 9"D x 14. 75"H, 21 lbs. CONNECTING THE SRS6. 5 AND THE SRS6. 5A Connecting to the SRS6. 5 is via positive and negative gold plated binding posts located on the rear jackplate. wire be used to ensure proper signal transfer. Carvin's standard cable for hookup is the PH series cable used in with the AD42 speaker cable adapter. Connect the SRS6. 5A powered monitors directly to your mixer or source device's output with a balanced XLR cable. [. . . ] If your speaker starts this protect cycle, simply reduce your input level to the unit. This should cure an over current condition. If the speaker continues the protect cycle after reducing the input level, the unit is probably in thermal protect cycle. [. . . ]