User manual CARVIN SW1801

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CARVIN SW1801. We hope that this CARVIN SW1801 user guide will be useful to you.

Lastmanuals help download the user guide CARVIN SW1801.


Mode d'emploi CARVIN SW1801
Download
Manual abstract: user guide CARVIN SW1801

Detailed instructions for use are in the User's Guide.

[. . . ] xxxxxx USA SPEAKER CABLES SW1801 Congratulations on your selection of the SW1801 Sub Woofer System. The SW1801 is the finest single 18" sub-woofer enclosure that Carvin has ever offered. Perfect for bands, DJ's, and permanent installations. From tight, punchy upper-bass to earth shaking sub-bass, the SW1801 can fulfill any professional sound reinforcement requirement easily. [. . . ] Be sure to note the total impedance to the amp so it is not lower than it's recommended impedance. SUGGESTIONS FOR OPTIMAL PERFORMANCE It is recommended to keep subwoofers on the floor as the floor enhances the low frequency wave to develop more acoustic output. Subwoofers may be hung but their efficiency is slightly lower when suspended. SW1801 FREQUENCY RESPONSE dBSPL 105 100 95 90 20 Hz 50 100 200 500 1K 2K 5K 10K 20K MODEL SW1801 SUB WOOFER SPECS: Frequency Response: Useable Low Frequency: Power Handling: Recommended Amp: Sensitivity: Nominal Impedance: Crossover Type: Connectors input & output: Woofer Enclosure Type: Enclosure Covering: Dimensions: Net Weight: Warranty: Options: 50 Hz to 450 Hz ±3 dB 42 Hz (-10 dB) 800 watts Continuous Power 250 to 1000 watts 98 dB SPL, 1 watt @ 1 meter 4 Constant Voltage Two 1/4" & two Twist-LokTM connectors Vented Box Duratuff IITM 24. 75"W x 24"D x 34"H 93 lbs. One Year Cover: CVS1801 WARRANTY Parts and labor are covered for 1 year on manufacturer's defects. Warranty does not cover burned out drivers caused by excessive power or distortion, or physical damage caused by general use, moisture or dust. CAUTION: Distortion from power amps can destroy drivers much faster than clean power. Contact Carvin's Customer Service at 800-854-2235 or returnsrepairs@carvin. com. Customer is responsible for shipping charges. For your records, you may wish to record the following information. Serial No. _____________________ Invoice Date_______________ 76-01800A 0902 c 12340 World Trade Drive, San Diego, CA 92128 (800) 854-2235 www. carvin. com SW1801P POWERED SPEAKER INPUT INSTRUCTIONS For any distance over 25', use a balanced source. Use the balanced XLR or 1/4" connectors featured on the rear connect plate. You may DAISY-CHAIN as many speakers as you wish. All connectors are wired in parallel. 12dB PAD To start the initial hook up, be sure the 12dB pad switch is in the "IN" position. This will be the least sensitive position for your input source. If your signal is weak, depress the Pad switch to the "OUT" position, which will raise the level of your powered speaker. SOFT LIMITING Unlike other limiters, the SPSTM incorporates an exclusive optoisolater limiter system, which does not add distortion when limiting. Soft limiting starts to occur when you approach the maximum output of your powered speaker allowing you to get more usable power out of your system without severe clipping. However, when you hear distortion, hard clipping or cutting out, reduce the overall level as you have exceeded the system's capacity. POWER/PROTECT When the system has been activated by the power switch, the LED will indicate GREEN. If the system should go into protect, the LED will indicate YELLOW which may occur if; a) one of the internal drivers short or b) if the power amp should require service. AC POWER The SW1801P is available in either 120V or 240V models. Always use dedicated circuits for powered speakers. Every Carvin SPSTM powered speaker is designed to be left on continuously in the case of permanent installations. SW1801P Read general information about the SW1801 enclosure for specs, warranty and precautions on the other side. REAR POWERED CONNECT PLATE MADE IN THE USA Serial No. SPSTM POWERED SPEAKER FEATURES Carvin's SPSTM SMART POWERED SPEAKERSTM are more than just another "power amp in a cabinet". They offer advanced electronics to perfectly control every speaker component. [. . . ] Daisy-chain as many powered speakers as you need for additional coverage. A 12 dB gain switch matches every audio source. A removable AC cord frees the enclosure when transporting. PRO SOUND REINFORCEMENT POWER 600 Watts CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN SW1801P CAUTION - TO PREVENT ELECTRICAL SHOCK DO NOT DEFEAT THE SAFETY GROUND ON THE POWER CORD - DO NOT REMOVE COVER . WARNING - TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE TO RAIN OR MOISTURE. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CARVIN SW1801

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CARVIN SW1801 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag