User manual CASIO 3147

[. . . ] MO0803-EA Operation Guide 3147 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully. · The actual level at which some functions are disabled depends on the watch model. · Frequent display illumination can run down the battery quickly and require charging. [. . . ] After that, barometric pressure and temperature measurements are taken every five seconds. · During barometric pressure measurements, the watch may not be able to update its timekeeping display contents normally. Correct timekeeping is maintained internally, however. ll L lll More than +4hPa +3hPa +2hPa +1hPa ±0hPa ­1hPa ­2hPa ­3hPa Less than ­4hPa ll 6 Operation Guide 3147 World Time Timekeeping Mode time City code Countdown Timer World Time displays the current time in 33 cities (29 time zones) around the world. · If the current time shown for a city is wrong, check your Home City time settings and make the necessary changes. · For full information on city codes, see the "City Code Table". · All of the operations in this section are performed in the World Time Mode, which you enter by pressing D. Hours Current time You can set the countdown timer within a range of one minute to 24 hours. An alarm sounds when the countdown reaches zero. · All of the operations in this section are performed in the Countdown Timer Mode, which you enter by pressing D. To set the countdown start time Minutes Seconds Current time in the zone of the selected city code To view the time in another city In the World Time Mode, use E (east) and B (west) to scroll through city codes (time zones). · When the currently selected time zone is one that includes mostly ocean, a value indicating the zone's UTC offset appears in place of a city code. 1. While the countdown start time is on the display in the Countdown Timer Mode, hold down A until the hour setting of the countdown start time starts to flash, which indicates the setting screen. · If the countdown start time is not displayed, use the procedure under "To use the countdown timer" to display it. To toggle a city code time between Standard Time and Daylight Saving Time DST indicator 2. Press D to move the flashing between the hour and minute settings. Use E (+) and B (­) to change the flashing item. · To set the starting value of the countdown time to 24 hours, set 4. Press A to exit the setting screen. OO'OO". 1. In the World Time Mode, use E (east) and B (west) to display the city code (time zone) whose Standard Time/Daylight Saving Time setting you want to change. Hold down A to toggle between Daylight Saving Time (DST indicator displayed) and Standard Time (DST indicator not displayed). · The DST indicator appears on the display whenever you display a city code for which Daylight Saving Time is turned on. To use the countdown timer Press E while in the Countdown Timer Mode to start the countdown timer. · When the end of the countdown is reached, the alarm sounds for five seconds or until you stop it by pressing any button. The countdown time is reset to its starting value automatically when the alarm sounds. · Press E while a countdown operation is in progress to pause it. · To stop a countdown operation completely, first pause it (by pressing E) and then press B. [. . . ] · Temperature measurements are affected by your body temperature (while you are wearing the watch), direct sunlight, and moisture. To achieve a more accurate temperature measurement, remove the watch from your wrist, place it in a well ventilated location out of direct sunlight, and wipe all moisture from the case. It takes approximately 20 to 30 minutes for the case of the watch to reach the actual surrounding temperature. 11 Operation Guide 3147 City Code Table Pressure Sensor and Temperature Sensor Calibration The pressure sensor and temperature sensor built into the watch are calibrated at the factory and normally require no further adjustment. If you notice serious errors in the pressure readings and temperature readings produced by the watch, you can calibrate the sensor to correct the errors. [. . . ]