User manual CASIO 4303

[. . . ] MO0510-EA Operation Guide 4303 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully and keep it on hand for later reference when necessary. Press B ten times to exit the setting mode. · The watch will also return to the Timekeeping Mode if you do not perform any operation for about three minutes. [. . . ] What you should do · Enter the Timekeeping Mode and try again. · Select 0, +1, E (GMT­5), C (GMT­6), M (GMT­7) or P (GMT­8) as your Home Time Zone. · Perform manual signal receive or wait until the next auto signal receive operation is performed. · Check to make sure the watch is in a location where it can receive the signal. · Select the correct Home Time Zone. · Enter the Home Position Adjustment Mode and adjust the home position. E (GMT Standard Time and ­5), C Daylight Saving Time (GMT ­6), M (GMT ­7), P (GMT ­8) About the Receiving Indicator The receiving indicator shows the strength of the calibration signal being received. For best reception, be sure to keep the watch in a location where signal strength is strongest. The receiving indicator is displayed while an auto or manual receive operation is in progress. Receiving indicator ||||| Weak (Level 0) Strong (Level 3) · Use the receiving indicator as a guide for checking signal strength and for finding the best location for the watch during signal reception. To perform manual receive 1. Place the watch on a stable surface so its 6 o'clock side Receiving is facing towards a window. Hold down A for about two seconds until R0 starts to flash on the display. · The second hand will move to 12 o'clock and stay there while actual reception is in progress. · The hour and minute hands continue to keep time normally. · Time calibration signal reception takes from two to ten minutes. Take care that you do not perform any button Receive successful operations or move the watch during this time. · When receive is successful, the display shows the time that receive was successful. · The watch will enter the Timekeeping Mode if you press A or if you do not perform any button operation for about three minutes. · When receive is unsuccessful, the display shows "xx". The watch will enter the Timekeeping Mode without changing the time setting if you press A or if you do not Receive failed perform any button operation for about three minutes. Timekeeping Hour hand Minute hand Second hand |||| To set the time and date manually 1. In the Timekeeping Mode, hold down B for about five 12 o'clock seconds. · This will cause the second hand to move to 12 o'clock. · The hour and minute hands do not move in the setting mode. Press B to cycle through settings in the sequence shown |||| below. |||| |||| Note · To interrupt a receive operation and return to the Timekeeping Mode, press A. Hold down B. [. . . ] The time calibration signals transmitted from Rugby (England), or Fort Collins (the United States) include both Standard Time and DST data. When the Auto DST setting is turned on, the watch switches between Standard Time and DST (summer time) automatically in accordance with the signals. · The default DST setting is Auto DST (At) whenever you select 0, +1, E (GMT ­5), C (GMT­6), M (GMT­7), or P (GMT­8) as your Home City code. · If you experience problems receiving the time calibration signal in your area, it is probably best to switch between Standard Time and Daylight Saving Time (summer time) manually. To change the Daylight Saving Time (summer time) setting 1. [. . . ]