User manual CASIO 4334

[. . . ] MO0607-EB Operation Guide 4334 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully. About This Manual (Light) · The measurement functions built into this watch are not intended for use in taking measurements that require professional or industrial precision. Values produced by this watch should be considered as reasonably accurate representations only. assumes no responsibility for any loss, or any claims by third parties that may arise through the use of this watch. Warning! · Button operations are indicated using the letters shown in the illustration. [. . . ] · The auto-repeat on indicator ( ) is displayed on the Countdown Timer Mode screen while this function is turned on. · Frequent use of auto-repeat and the alarm can run down battery power. Auto light switch on indicator This watch has an EL (electro-luminescent) panel that causes the entire display to glow for easy reading in the dark. The watch's auto light switch turns on illumination automatically when you angle the watch towards your face. · The auto light switch must be turned on (indicated by the auto light switch on indicator) for it to operate. · See "Illumination Precautions" for other important information about using illumination. Alarm Alarm on indicator AM indicator To turn on illumination manually In any mode, press L to illuminate the display for about 1. 5 seconds. · The above operation turns on illumination regardless of the current auto light switch setting. When the alarm is turned on, the alarm sounds when the alarm time is reached. You also can turn on an Hourly Time Signal, which will cause the watch to beep twice every hour on the hour. · All of the operations in this section are performed in the Alarm Mode, which you enter by pressing C. About the Auto Light Switch Turning on the auto light switch causes illumination to turn on, whenever you position your wrist as described below in any mode, except for the Hand Setting Mode setting screen. Moving the watch to a position that is parallel to the ground and then tilting it towards you more than 40 degrees causes illumination to turn on. · Wear the watch on the outside of your wrist. Alarm time (Hour : Minutes) Hourly time signal on indicator Parallel to ground More than 40° To set the alarm time 1. In the Alarm Mode, hold down A until the hour setting of the alarm time starts to flash, which indicates the setting screen. · This operation turns on the alarm automatically. Press C to move the flashing between the hour and l ll minute settings. While a setting is flashing, use D (+) and B (­) to change it. · When setting the alarm time using the 12-hour format, take care to set the time correctly as a. m. Press A to exit the setting screen. lll Alarm Operation The alarm sounds at the preset time for 10 seconds, regardless of the mode the watch is in. · To stop the alarm tone after it starts to sound, press any button. Warning!· Always make sure you are in a safe place whenever you are reading the display of the watch using the auto light switch. Be especially careful when running or engaged in any other activity that can result in accident or injury. Also take care that sudden illumination by the auto light switch does not startle or distract others around you. · When you are wearing the watch, make sure that its auto light switch is turned off before riding on a bicycle or operating a motorcycle or any other motor vehicle. Sudden and unintended operation of the auto light switch can create a distraction, which can result in a traffic accident and serious personal injury. To test the alarm In the Alarm Mode, hold down D to sound the alarm. [. . . ] Press C 10 times to display the temperature unit setting screen. Use D to switch between Celsius (°C) and Fahrenheit (°F). · The initial factory default and the initial default after battery replacement is Celsius (°C). After configuring the setting you want, press A to exit the setting screen. [. . . ]