User manual CASIO HZ-600

[. . . ] Never place heavy objects on the power cord, and never expose it to direct heat. A damaged power cord creates the danger of fire and electrical shock. · Use only the AC adaptor specified for this unit (optional AD-A95100). Use of another AC adaptor creates the danger of fire and electrical shock. [. . . ] · If the tape does not come out normally, turn off power and start again from step 1 above. OK! Tape Width Specification Important!· When using 6mm tape, using certain character sizes can cause characters to run off the top or bottom of the tape. Be sure to use the following procedure to tell the Label Printer when you are using 6mm tape. NO! · Make sure that the tape does not extend too far past the tape guide. If it does, cut off the end with a pair of scissors. To specify 6mm tape width 1. Press H, J, K or L to change the setting shown on the display between ON (6mm tape) and OFF (other tape width). When the tape width setting is the way you want it, press SET to register it. · The tape width you set remains in effect until you change it, press ON or reset the Label Printer's memory. E-8 Part 3 Inputting Characters and Symbols This part of the manual tells you how to input characters. To make things easier to understand, we call everything you input a character, regardless of whether it is actually a letter, number, or symbol. Explanations here all use the default settings that are in effect from the initial power-on screen. For information on using other character styles, effects and sizes, see page 12. · You can input up to 63 characters per label. Auto feed is in effect when this indicator is not on the display. · After you finish printing when using manual feed, be sure to always press FUNCTION and then PRINT (FEED) to feed the tape before cutting it. If you don't you will cut off part of the printed text. · 6mm tape indicator This indicator appears when you use the procedure on page 8 to specify you are using 6mm tape. No indicator is shown when you are using other (9mm, 12mm, 18mm) tape. · Cursor The cursor shows the next input position. Any character you input appears at the point where the cursor is located. · Character position marks These marks show where characters will appear as you input them. This part of the display is always blank when you turn power on. · If you input a wrong character, press BS to delete it and input again. See page 11 for other details on editing text. When you reach the end of a line of text, press B (the L cursor key) to input a newline mark. [. . . ] Possible Cause Ink ribbon cassette loaded while the ink ribbon is slack. Action Remove the ink ribbon cassette and check to make sure the ink ribbon is not broken. Next, take up any slack in the ink ribbon and then reload the tape cartridge. · Before loading an ink ribbon cassette into the label printer, always make sure you take up any slack in the ink ribbon first. [. . . ]