User manual CASIO QW-358

[. . . ] · Pressing this button while the alarm is sounding stops the alarm. 2 Alarm Mode selector SNZ: Snooze alarm on ON: Alarm on OFF: Alarm off 3 UP (+) / DOWN (­) buttons Use these buttons to change the alarm time or the setting that is flashing on the display. 4 °C/°F button Press this button to toggle the temperature units between Celsius and Fahrenheit. 5 SET button Use this button when setting the current time. [. . . ] 5 SET button Use this button when setting the current time. 6 CLEAR button Press this button to clear the currently displayed high/low temperature or humidity. button Press this button to display the high and low temperature values. 8 RESET button Press this button to reset the clock after replacing its batteries. 9 MAX/MIN HUMIDITY button Press this button to display the high and low humidity values. · Holding down UP (+) or DOWN (­) changes the flashing digits at high speed. · You can set the year in the range of 2000 to 2039. The day of the week is set automatically in accordance with the date setting. · Pressing UP (+) or DOWN (­) while the Time Setting Screen is on the display causes the seconds count to be reset to 00. · Each press of UP (+) or DOWN (­) while the 12-hour/24-hour Timekeeping Screen is on the display toggles between 12-hour and 24-hour timekeeping. · Though temperature readings are displayed up to 0°C (32°F) and greater than 41°C (105°F), note that such readings are actually outside the guaranteed temperature range of this clock. Switching between Celsius and Fahrenheit Celsius (°C) °C · Push the °C/°F button (4) to select either Celsius (°C) or Fahrenheit (°F). Fahrenheit (°F) MAX/MIN HUMIDITY button (9) °F °C/°F button (4) · To clear the high humidity and low humidity memory, press the MAX/MIN HUMIDITY button (9) to display the current high/low values, and then press the CLEAR button (6). Note that the current high/low values are displayed for only about five seconds, and you need to press the CLEAR button (6) during that period. High Temperature and Low Temperature Memory · The clock remembers the high and low temperatures it measured since the last time its temperature memories were cleared. You can recall these values as shown below. Current temperature and humidity High temperature and low temperature CLEAR button (6) BATTERY REPLACEMENT Replace batteries whenever the display of the clock becomes dim and difficult to read. Open the battery compartment cover as shown in the illustration. Make sure that their positive (+) and negative (­) ends face in the correct directions. If you load batteries incorrectly, they can burst and damage the clock. Be sure to press the RESET button (8) after replacing batteries. MAX/MIN TEMP. button (7) · To clear the high temperature and low temperature memory, press the MAX/MIN TEMP. button (7) to display the current high/low values, and then press the CLEAR button (6). Note that the current high/low values are displayed for only about five seconds, and you need to press the CLEAR button (6) during that period. [. . . ] button (7) to display the current high/low values, and then press the CLEAR button (6). Note that the current high/low values are displayed for only about five seconds, and you need to press the CLEAR button (6) during that period. New data starts to be stored after memory is cleared. Battery precautions · Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician immediately. [. . . ]