User manual CASIO QW-549

[. . . ] The 1st Alarm is the alarm that sounds when the current time reaches the alarm time you set. The Next Alarm sounds after passage of the time setting of the NEXT ALARM dial, starting from the point that the 1st alarm begins to sound. The Next Alarm also has a snooze feature. [. . . ] The alarm on/off setting affects both the 1st Alarm and the Next Alarm. You cannot turn the 1st Alarm and Next Alarm on and off individually. The Next Alarm sound is relatively louder than the 1st Alarm sound. To set the alarm 1. Rotate the Alarm setting dial in the direction indicated by the arrow marked on clock to move the alarm hand to the 1st Alarm time setting you want. Rotate the NEXT ALARM dial from 1st Alarm to the Next Alarm setting you want to use. · You can set the Next Alarm to any time from 5 to 60 minutes, in 5-minute steps. · If the Alarm ON/OFF switch is already set to ON, always be sure to change its setting to OFF and then back to ON again after making alarm time setting changes. · (QW-549) This product has a luminous resin face that accumulates light for easier reading. · (TQ-451) This product uses luminous paint for face markings and on its hands. LIGHT LUMINOUS RESIN LUMINOUS PAINT TQ-451 X X O QW-549 O O X REPLACING THE BATTERY Low battery power is indicated when timekeeping slows or stops completely. Should either of these symptoms occur, replace the battery immediately. Do not leave a low or dead battery in the clock. Pressing down at the point marked on the battery compartment cover, slide the cover to remove it. Make sure that its positive (+) and negative (­) ends are facing correctly. If you load the battery incorrectly, it can burst and damage the clock. [. . . ] If you load the battery incorrectly, it can burst and damage the clock. Replace the battery compartment cover. Battery precautions · Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician immediately. [. . . ]