User manual CASUALPLAY BEAT S - GRUPO 1-2

[. . . ] The safety of your child depends on the correct use of the seat. Do not hesitate to contact us if you have any queries (Tel. , e-mail, see the back of these instructions). Read these instructions carefully before using the article and keep them for any future reference. [. . . ] €¢ Adjustment of the crotch strap: Press the adjuster and at the same time place it into the desired position (fig. 7a) , so that the pelvis is firmly engaged. GROUP 2 (15 - 25 kgs) Fitting the safety car seat in forward-facing position with a three-point safety belt (car seat belt) (see illustrations 1b - 3b) The child will never be fixed with the safety car seat harness straps, but only with the three point car belt. Pass the buckle through the crotch strap slot. Make sure the buckle is kept under the seat. €¢ Install the child seat on the front or rear seat of the car in the lowest position (sitting), never reclined. Rotate the guide to the desired position, making sure that there are no kinks or twists in the car seat belt. Harness adjustment to child growth (see illustrations 1c - 2c) • Use the knobs placed on both sides of the car seat to adjust the shoulder straps (fig. 2c), never over or under the child’s neck. NOTE: It is only possible to adjust the harness height by using the side handles, do not alter the height by changing the position of the harness using the slots on the rear part of the seat. Harness adjustment (see illustration 3c) • It is recommended to adjust harness length to child size before fitting the child seat in car. To tighten the shoulder straps, pull at the end of the belt to the tensor straps TMS until getting the adjustment wished (A). To slacken the shoulder straps press the TMS in the B arrow direction and pull the shoulder straps with the other hand. Then loosen the abdominal belt by pressing the red button of the safety buckle (B). NOTE: Harness must be reasonably tight, it should restrain but not make child uncomfortable. Check that no strap is twisted while child is seated. The importance of ensuring that any lap strap is worn low down, so that the pelvis is firmly engaged, shall be stressed. 13 Recline (see illustration 4c) • The AUTOPLAY seat can easily change position from upright to recline with only one hand by using the adjustment handle at the front of the seat. NOTE: Check that seat is not between two positions. A “click” sound will confirm that child seat is locked in the right position. Fastening buckle according to the model (see illustrations 5c - 6c) • To close the harness buckle, check shoulder straps are not twisted , joint the two parts and introduce them into the female part with red button and push until to hear a “click” sound. Removing the harness (diagrams A - F) • Loosen the harness by pressing the rear part of the TMS downwards and pulling the chest straps underneath the protectors with the other hand (fig. [. . . ] €¢ Follow the same steps in reverse order to fit the upholstery. removing the upholstery (According to model. See diagram K) • Loosen the harness by pressing the rear part of the TMS downwards and pulling the chest straps underneath the protectors with the other hand. €¢ Release the clasps on the backrest (fig. [. . . ]