User manual CASUALPLAY SONO

[. . . ] • This restraint system should always be installed facing backwards. It should be secured using the three-point seat belt of the vehicle, approved under UN/ECE-16 regulations or equivalent standards. € The safest position for the safety restraint system is on the back seat of the vehicle. • The original equipment must not be modified. [. . . ] € Make sure that the upholstery on the vehicle seat does not make it difficult to tighten the seat belt. € Remember that you are responsible for the child’s safety. It is approved under Regulation Nº44, 04 series of amendments, for general use in vehicles and will fit most, but not all car seats. Correct installation is possible if the vehicle manufacturer states in the instruction manual that a “UNIVERSAL” restraint system for this age group can be used in the vehicle. This restraint system has been classed as “UNIVERSAL” complying with stricter conditions than the previous designs that do not include this note. If in doubt, consult the manufacturer or retailer of the safety seat. IMPORTANT Appropriate use only in vehicles fitted with 3-point seat belts with or without retractor, approved under UN/ECE 16 or equivalent standard. wARNING: Never leave the child unattended. WARNING: Do not use the reclined cradle once your child can sit unaided. WARNING: This reclained cradle is not intended for prolonged periods of sleeping. WARNING: It is dangerous to use this reclined craddle on an elevated surface, e. If your child needs to sleep, he should be placed in a suitable cot or bed. € Do not use this product if any of the parts are broken or missing. € Do not use accessories or replacement parts that have not been approved by the manufacturer. nOTE: The SONO is compatible with the BASE FIX SONO. INSTRUCTIONS FOR USE CHANGING THE POSITION OF THE HANDLE To change the position, press and hold button A while pressing button B. Push the handle forwards or backwards, to the required position. 02): A: Handle forwards for installation in the vehicle. ADJUSTING THE BACKREST • Lift the lever on the back of the backrest to adjust the reclining position (fig. It will click when the backrest is correctly locked into place. OPENING AND CLOSING THE HARNESS BUCKLE • Bring the two parts of the harness chest straps together and insert them into the female part of the buckle (fig. Then press both until it clicks indicating it is correctly fastened (fig. [. . . ] € Remove the chest protector pads and the reduction cushion. Pass the harness straps through the vents in the upholstery. € Take the upholstery off, starting with the front part. UNISYSTEM This exclusive fastening system means that the Sono can be used on the following pushchairs: Avant, Livi, Kudu, Kudu 4, S4, S-Twinner. [. . . ]