User manual CAT EYE CC-2000 (SOLAR)

[. . . ] · Dispose of used batteries according to local regulations. · LCD screen may be distorted when viewed through polarized sunglass lenses. Before using the computer, please thoroughly read this manual and keep it for future reference. WARNING / CAUTION ·Sensor * After replacing the computer battery, follow the procedure described in SETTING. When the speed is not displayed even after adjusting correctly, replace the battery. After replacement, check the positions of the sensor and magnet. Troubleshooting The sensor signal icon does not flash (the speed is not displayed). [. . . ] (Move the computer near the sensor, and turn the front wheel. If the sensor signal icon flashes, this trouble may be a matter of transmission distance due to battery drain, but not any malfunction. ) Wireless Sensor Check that the clearance betw een the sensor and m agnet is not too large. (Clearance: w ithin 5 m m ) Check that the m agnet passes through the sensor zone correctly. Adjust the positions of the magnet and sensor. Is the com puter installed at the correct angle?Back of computer must face toward the sensor. Check that the distance betw een the com puter and sensor is correct. (Distance: w ithin 20 to 70 cm ) Install the sensor within the specified range. Is the com puter or sensor battery weak?In w inter, battery perform ance dim inishes. Please write or type your name and address clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights. 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan Attn: CATEYE Customer Service Section Service & Research Address for USA CatEye North America 2300 Central Ave Suite L Boulder, CO 80301 Phone : 303. 443. 4595Toll Free : 800. 5CATEYE Fax : 303. 473. 0006 E-mail : service@cateye. com URL : http://www. cateye. com F Battery case cover Starting/Stopping measurement Switching computer function Resetting data Measurements start automatically when the bicycle is in motion. During measurement, km/h or mph flashes. Pressing MODE switches the measurement data at the bottom in the order of OPERATION FLOW. Pressing and holding MODE on the measuring screen returns the measurement data to 0. The odometer is not reset. STANDARD PARTS #160-2190 : Parts kit #160-2193 : Bracket Power-saving mode If the computer has not received a signal for 10 minutes, power-saving mode will activate and only the clock will be displayed. When the computer receives a sensor signal, the measuring screen reappears. [. . . ] The odometer is not reset. STANDARD PARTS #160-2190 : Parts kit #160-2193 : Bracket Power-saving mode If the computer has not received a signal for 10 minutes, power-saving mode will activate and only the clock will be displayed. When the computer receives a sensor signal, the measuring screen reappears. If another 2 weeks' inactivity elapsed, SLEEP will be displayed on the screen. Pressing the MODE in SLEEP mode brings up the measuring screen. #160-2196 : Speed sensor #166-5150 : Lithium battery (CR2032) Calorie Consumption *2 The calorie consumption data is only the accumulated value that is calculated from the speed data of every second. [. . . ]