User manual CAT EYE CC-5000

[. . . ] Bei der Rückgabe des Gerätes zur Reparatur packen Sie es sorgfältig anbei. Achten Sie darauf, Ihren Namen und Ihre Anschrift klar und deutlich lesbar auf die Garantiekarte zu schreiben, damit das Gerät so schnell wie möglich nach Beendigung der notwendigen Reparatur/Einstellung an Sie zurückgesandt werden kann. Anschrift bei Garantieansprüchen CO. , LTD. #169-6167 Center Mount Bracket Kit Kit de montage central del l´unité principale Halterung für Montage en der Lenkermitte Stuurbocht Bevestinging Set Kit di Montaggio al Centro del manubrio Kit Soporte para Montaje Central 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan z. H. : CAT EYE Kundendienstabteilung oder wenden Sie sich bitte an den entsprechenden Importeur. GARANTLEBEPALINGEN 1 jaar garantie, alleen geldig op de computer (accessoires, aansluitingen en gebruik van batterij uitgezonderd) Mochten er problemen optreden gedurende normaal gebruik, dan geschiedt reparatie of vervanging kosteloos. [. . . ] If main display does not show any figures, press either M button or S/S button to release from power saving function. Spin the wheel to check if sensor pulse symbol flashes. If not, adjust relative positions of magnet and sensor following the instructions. A. G. Main Display (Speed) Sensor Pulse Symbol Mode Symbol Speed Scale Symbol Auto Mode Symbol Sub-Display (Selected Function) M (Mode) Button H. 3. S/S (Start/Stop) Button Set Button Battery Case Cover Contact Bracket Wire Sensor 4. 10. Sensor Bands-A (S)(L) Sensor Bands-B Magnet Sensor Band Rubber Pad Bracket Rubber Pad (2 pcs. ) Wire Securing Tape Sensor Band Screw OPEN Fig. 16 CLOSE HOW TO REPLACE THE BATTERY CR1620 /CR1616 MXS ODO DST TM AVS Fig. 1 BUTTON FUNCTION · M button (Fig. 1) Changes the display in the order shown in fig. 1, and data is displayed on the sub-display. *If held over 2 seconds, 12-hour clock appears. Turn main unit over, remove battery case cover with coin and insert a new lithium battery properly (CR1620 or CR1616) with the (+) pole upward (fig. 17), and close the cover securely. * Please make sure to do the All Clear operation after replacing battery, and to set the unit again. Fig. 17 MEASURING AND DISPLAY FUNCTIONS DST Current Speed 0. 0(3. 0) - 65 mile/h(27inch) ±1 mile/h under31 miles/h This is always displayed on the main display and updated once a second. SPD ODO Total Distance (Odometer) 0. 0 - 9999. 9 mile ±0. 1 mile This is continuously measured until battery wears down or all clear operation is done. * 2 seconds may be elapsed if mount the main unit to the bracket with this function on. POWER SAVING FUNCTION When main unit is left without receiving any signal for 60-70 minutes continuously, power supply is shut down and main unit will display ( ) only as the figure. By pressing M button or S/S button, or by receiving signal, this function is released. magnet Fig. 8 sensor band B (2) Setting Speed Scale Preform all clear operation. ODO will be dissensor band A Fig. 9 played and 216 cm is set. For revision, press S/S button to increase the number by one. To increase rapidly, hold down the button. When the sensor band B desired number appears, press M button. ODO will be displayed, and rubber pad the desired number is set. sensor band A parallel Fig. 10 (4) Resetting or changing the wheel circumference Set main unit in ODO with M button, and stop it with S/S button. The stored number will flicker on the sub-display. Revise the number as desired according to the instructions in (3). sensor band A Setting the clock time (Fig. 7) Press M button over 2 seconds to select , and stop it with S/S button. Then press SET button, and minutes flash. Press S/S button to advance minutes by one. [. . . ] Wind the wire round the outer tape cable and adjust length. Loosen the wire in the area marked with the arrow so that the wire does not hinder handlebar operation. Fig. 14 wire Fig. 12 MAINTENANCE/PRECAUTIONS · Do not leave the main unit exposed to direct sunlight when the unit is not in use. · Do not disassemble the main unit, sensor and magnet. [. . . ]