User manual CAT EYE CC-6000

[. . . ] The signal reception range may shorten as a result of low temperature or lowered battery power. In the following places and circumstances, interference may occur, resulting in malfunction: · Near railroad crossing; in train cars. · Near other cordless devices/television/personal computer/high power lighting system. · Near the places where strong electromagnetic wave is generated; near television/ radio station; near radar base. [. . . ] B) Spoke Secure the sensor to fork leg as shown (fig. NOTE: The distance between the computer and the sensor must not exceed 70 cm--if the sensor is too far away from the computer head, the speed signal will not register on the computer. For best results, mount the sensor as high on the fork leg as reasonably possible, so that the sensor is within Front Fork transmission range to the computer. However, the sensor must be close enough to spokes to allow proper disSensor Screw 4 tance to magnet (see below). Front Fork Press the SET button to lock in your choice---OR--if you want to input previous mileage, hold the MODE button (before pressing the SET button) for 2 seconds. · Flashing Odometer digits will appear. · MODE button increases the digit number. · START/STOP button moves to the next digit. · Press the SET button when complete. SET MODE increase the figure MODE move to the next digit Sensor Base (fig. C) 2 Sensor Base ST. /STOP NOTE: When the wheel rotates, the magnet MUST line up with the mark on the sensor. ALSO NOTE: Magnet must pass within 5 mm of the sensor--if not, it will not trip the sensor as it passes, and the computer will not register speed. Adjusting the sensor position higher or lower on the fork leg or by rotating the sensor on the fork mount may be required to achieve proper distance to the wheel magnet. Less than 5mm SET 3 2 Magnet's center Marking line 3 2 Spin · · · · · · Wheel circumference number is shown. If mph is selected, it becomes 12-hour clock. Returns to above mode MODE SET SET Increases figure MODE Clock 0:00-23:59 [1:00-12:59] SET Decreases figure ST. /STOP Troubleshooting No display. Replace it with a new one and do all clear operation. (Before this operation, write down your Odo data, and input it again after all clear operation. In this way you can continue to accumulate your Odo. ) Cannot start measuring by START/STOP button. To operate manually, switch off the Auto Time. (Current speed does not appear. ) [If the sensor pulse indicator fails to flash, first spin front wheel to align computer with sensor. Indicator will flash if computer is working. If not, this will pinpoint the problem to be: 1. distance between sensor and unit is over 70cm. ] Is the clearance between the sensor and the magnet too large?Are the magnet's center and the sensor's marking line aligned?Re-adjust the positions of the magnet and the sensor. [. . . ] * The specifications and design are subject to change without notice. Limited Warranty 2-year warranty for computer/sensor only (excluding parts and batteries) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly on the warranty certificate, and send it back to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. After being repaired or replaced, the product will be shipped back to the customer. [. . . ]