User manual CAT EYE CC-7000

[. . . ] Do not use thinners, benzene, or alcohol on the computer. Troubleshooting No display. Replace it, and re-enter the correct information. Pressing the START/STOP button does not calculate Elapsed Time. Is the To start/stop measurement using the START/STOP button, turn off Auto-mode. [. . . ] Thus, the sensor and computer must be relatively close. If the temperature or battery power is low, they may need to be even closer than normal. The sensor must be installed at the top of the fork, and the distance between the sensor and the computer should not exceed approximately 70 cm. Install the computer on the stem, with its bottom surface facing the sensor. (Take into account the angle of the stem. ) Interference may occur, resulting in malfunction, if the computer is: · Near a TV, PC, radio, motor, or in a car or train. · Close to a railroad crossing, railway tracks, TV stations and or radar base. · Close to a second bicycle with wireless sensors. #169-6570 Bracket kit Correct installation of sensor and magnet #169-9691 Wheel Magnet A Attach the magnet 3 so that it passes through the sensor zone of the sensor 2. B Be sure to have a 5 mm-or-less clearance between the sensor 2 and magnet 3. Replacing the Battery · Computer If the Wheel Size icon ( or ) flashes, replace the battery. The Total Distance can be entered manually. Before removing the battery, note the current Total Distance. Install a new lithium battery (CR2032) with the (+) side facing upward. In Auto-mode, starting/stopping measurement using the START/ STOP button is impossible. · Manual measurement If the icon does not light, starting/stopping the measurement using the START/STOP button is possible. * Use the menu screen to toggle between Auto-mode ON and OFF. For further information, see the MENU FLOW. #169-9690 Hi-Power Wheel Magnet Switching Mode symbol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . b Press the MODE button to switch measurement according to the OPERATION FLOW. Press the MODE button for 2 seconds to switch from Main to Sub measurement. · Sub measurement When Main measurement starts/stops, Sub measurement starts/ stops accordingly. Note, however, that the main and sub measurements must be reset individually. Resetting Main and Sub measurement at different times allows interval measurement to be carried out. * In the sub measurement the pace arrow compares the current speed to average speed 2. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] Pressing the MODE or START/STOP button in SLEEP mode brings up the measuring screen. Dual Wheel Size Two wheel sizes (Wheel sizes and ) can be registered on the computer. This is useful when the computer is shared between two bicycles or when one bicycle uses different wheel sizes at different times. Wheel size B has pre-programmed for a 26x1. 95" size tire. * Use the menu screen to toggle between and . [. . . ]