User manual CAT EYE CC-HB100 (HEART RATE MONITOR)

[. . . ] ® ® CC-HB1OO WITH HEART RATE MONITOR FUNCTION E Introduction Thank you for purchasing CATEYE CYCLOCOMPUTER Model CC-HB100. As well as cyclocomputer functions, this model has heart rate monitor functions, which enables safe and scientific training, by monitoring heart rate with a Wireless Heart Rate Sensor. Double pulse wireless heart rate transmission helps prevent interference caused by shocks and outer noises, offering the most accurate measuring. In addition to functioning as a cyclocomputer, it can be used as a heart rate monitor for other noncycling exercise programs. [. . . ] The electrode areas should be contacting your skin closely (Fig. If attaching it on underwear, carefully moisturize electrode areas (Fig. Note: In cold or dry conditions, lightly moisturizing electrodes will correct any Fig. 21 10 Fig. 22 Transmitter measurement errors that may result. Adjust the position of the transmitter to locate it at the center of your lower chest (under your breast) (Fig. Check if the power saving function of the main unit is off. If it is still on, release it by pressing either the right or left button. Place the main unit in front of your body, and check if and if your heart rate is displayed. If it doesn't work, re-adjust the location of the wireless heart rate sensor and moisturize the electrode area. Note: When the main unit is used independent of the bicycle, or the bicycle is stopped, switch off the Auto (automatic start/stop) function. If auto function is on, average heart rate can not be displayed. E 4. Setting Upper/Lower Heart Rate Limit Fig. 23 Get M mode by pressing the left button, and press the right button to get stop state. First, the figure for upper limit flashes on the upper display (Fig. 23), so get your desired number of the upper limit by pressing the right button to increase and the left to decrease. To increase/decrease rapidly, hold down the button. By pressing the Set button, this upper limit is set; and then the figure on lower display flashes. Again get your desired number of the lower limit by the same process. By pressing the set button again, the setting operation is complete. * Once the upper/lower limit is set, the alarm symbol will appear when your heart rate exceeds/drops down the limits (Fig. 24). Over Upper Limit Below Lower Limit Fig. 24 Notice - Battery Life Update: The expected battery life in the chest transmitter is approximately 2 years (average use of one hour per day). If the Heart Rate reading on the computer seems to be lower than actual or is not responding, the transmitter battery is at the end of it's useful life. Please replace the battery in the chest transmitter with a fresh CR2032. Measuring and Display S Current Speed Always displayed on the speed display and updated once a second. 0. 0 (3. 0) - 65. 9 mile/h [0. 0 (4. 0) - 105. 9 km/h] 11 E O Total Distance Continuously counted until the battery wears down. [. . . ] When you are not measuring heart rate, remove it from your chest. 1. Loosen and remove the 8 screws at the back of the transmitter, and take the cover (Fig. Load a new battery (CR2032) with the (+) pole upward. Fix the packing carefully into the cover, and place it back on the transmitter body. [. . . ]