User manual CAT EYE GAME BIKE CONTROL

[. . . ] Speed signal Right-hand stick/R3 button Analog mode switch * Certain software does not work well with this device due to differences in button functions. In such cases, changing the function assigned to particular buttons will allow these software packages to work. For further information on how to change these functions, see "Changing button functions". Vibration function The GAMEBIKE Controller is a virtual game controller with an integrated vibration function. [. . . ] Caution Depending on the software, while moving the handlebar from Left to Right, the steering reaction on the game does not work. Min. L STEERING LEVEL SPEED LEVEL R SELECT ANALOG START STEERING LEVEL Speed sensitivity Slow Fast · Adjusting the speed sensitivity Turn on the "Playstation2", then slide the speed sensitivity control of the GAMEBIKE Controller while operating the pedal of the bicycle on the race screen to adjust the speed sensitivity as required. Caution Depending on the software, while pedaling, the speed of the game does not register. This will cause the game not to move forward. L STEERING LEVEL SPEED LEVEL R SELECT ANALOG START SPEED LEVEL Button Function change In the case of software with different button functions, change functions as follows: The buttons to which functions can be assigned are green, pink, red, blue, L1, L2, R1 and R2. <Operation> Keep pressing the SELECT button until the following steps are completed: 1. Press the blue (or pink) button depending on the function to be changed. The LED will change from constantly lit to blinking. 2. Press the default accelerator (or brake) button in the software currently being used. The LED will change stop blinking and will be lit continuously, signifying that the function change is now complete. (If analog mode is OFF, the LED will be off, signifying that the function change has been completed. ) · Revert to the original button function While pressing the SELECT button, press the speed button (blue) or brake button (pink). FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. 3 Symbols Legend E Symbol marks used for safety precautions in this manual The descriptions accompanying the following symbol marks in this manual refer to very important issues in terms of your safety and handling of the unit. You are strongly urged to observe these precautions carefully. Warning Caution Important Failure to observe this warning could result in serious injury or death. Failure to observe this warning could result in physical injury or damage to the GAMEBIKE. Operations which require caution, items which should be observed in particular as well as certain additionnal information are presented in this manual. This symbol mark denotes helpful information ensuring proper usage. Reference GAMEBIKE Controller usage cautions! Caution · It has been reported that, in rare cases, some people have experienced certain physical symptoms, for example muscle spasms or temporary loss of consciousness as a result of stimulation from strong light rapidly changing on-screen images. Persons who have experienced such symptoms should consult a doctor before using this device. Moreover, if such symptoms should occur while watching the gaming screen, please consult a doctor immediately. [. . . ] If the unit gets an electrostatic shock, it can be reset by pressing the reset key or remove the batteries and put them back in. Specifications Compatible gaming devices Size (W x H x D) Weight Operating temperature range SONY Playstation, Playstation2 (6. 3" x 2. 8" x 4. 5") (160 mm x 71 mm x 115 mm) Approx. 0. 66lb (0. 3kg) Same as applied game device. *Specification and actual appearance of components might change without notice due to improvements. Warranty/Repairs. Service. 2-year Warranty: Applicable to GAMEBIKE Controller only (Excluding accessories) If the device becomes defective through normal use, it will be repaired or replaced free of charge. Send the device and warranty card to us directly, filling in the purchaser's name, address, date of purchase and a information regarding the malfunction. [. . . ]