User manual CAT EYE TRIPLE SHOT

[. . . ] · Never use damaged components (e. g. , cables, etc. ). Send any damaged components to our customer service department for repair. · The light unit may become extremely hot when on or immediately after it is turned off. · Do not place it within children's reach. [. . . ] Mount a rubber pad and the bracket onto the handlebar. 2 thicknesses of rubber pads are supplied; if necessary, cut the rubber pad to fit. Tighten and then close the lever to secure it. Make sure the bracket does not rotate on the handlebar. CAUTION!: Be sure to adjust the angle of the light's beam by referring to the "How to Adjust Beam Angle" section in this manual before operating the lighting system. Orange Light : Connected to power source · Be sure to use only the supplied battery charger. This charger Blinking Red Light : Charging can accept 100-240 volts. Green Light : Charging is completed · Do not completely remove the battery unit from the battery bag. · After charging, return the battery to its original storage state. Do not allow water to enter the battery bag. · The standard charging time and run time are guideline values and depend on the operating environment. · If the battery unit repeatedly does not meet the proper run time even though it is fully charged, it might be at the end of its operating life. Replace the old battery unit with a new one. The used battery unit should be disposed of properly according to local regulations. Bracket Rubber pad Quick lever (For H32 only) Handlebar or 1. Remove the battery bag from your bicycle and open the bag. Connect the jack to the battery charger. Plug the battery charger to an AC outlet. NOTE: When charging is complete, the indicator light changes from flashing red to green. When charging is complete, unplug the charging adapter. Refer to the figures below to rearrange the cable and use the seal strap to tightly close the opening. CAUTION!: When securing the battery to the frame, make sure the fixing strap attaches to the center of the battery unit. Charging Indicator To AC Power Outlet Battery Charger Battery Unit After Charging Cable Arrangement Mounting Light Unit/Switch Unit Mounting Light Unit Mount the light unit onto the bracket. To remove unit after use, pull it out while pressing the button on the bracket. CAUTION!: Make sure the light unit is cool to the touch before removing it. Light Unit Charging jack Seal Strap Button Slide in Standard charging time Plug Approx. [. . . ] NOTE: The battery can also be mounted on alternate positions on the bicycle. However, please make sure that the seam of the battery bag is facing down, and the fold line is in front. This will help prevent any water from entering the bag. Light Unit/ Switch Unit Fold Line Seam Top Tube Gear & Brake Cables Battery Unit/ Battery Bag Battery Bag Set Battery Charger Bracket H31 H32 SPECIFICATIONS Battery Unit --------------- Nickel hydride battery (Ni-MH/12V 2700mAh) Battery Charger ---------- CHR-2700(AC100V-240V 50/60Hz 0. 5A) Operating Time ---------- Approx. 3. 3 hours Standard charging time - Approx. [. . . ]