User manual CATEYE HL-NC250

[. . . ] Please keep this manual, along with the warranty card, for future reference. Bracket Lamp Unit Lamp Body Warning!!!Never touch the lamp body until thoroughly cooled. To install, slide the lamp body forward onto the lamp bracket until it clicks into position. To remove the lamp body, slide it backward while pushing the lever. [. . . ] Never apply paint thinner, benzine or alcohol; damage will result. Angle of Beam Switch on the light at night in flat place, and adjust the angle vertically. (It is also adjusted 10° horizontally. ) To adjust, loosen the screw of the bracket a little. In addition to its high brightness, the beam is widely diffused. When using this light on public roads, be sure to adjust the angle downward so as not to blind oncoming traffic. REPLACING BOTTLE BATTERY By preparing a spare bottle battery, you can continue to use the light and the time for night riding will be extended. Turn the battery cap counterclockwise and open it. Disconnect the inside jack and replace the bottle battery. Note: After replacing, securely connect the jack again. Note: When closing the battery cap, be careful not to catch dust around the rubber ring. * The bottle battery can be charged without the battery cap. In this case, connect the plug of the charger directly to the jack inside of the bottle battery. 1 2 Battery cap Jack HOW TO CHARGE Use only the included battery charger in an AC outlet for charging. Insert the plug of the battery charger into the jack of the bottle battery (or the jack inside of the battery cap). Plug the battery charger into an AC outlet. * The standard charging time is 8 hours if no charge is left in the battery. Never charge the battery for more than 24 hours; battery damage will result. After charging, unplug the battery charger and pull out the plug. Note: Be sure to unplug the battery charger after charging. Note: To make full use of the bottle battery's capacity, recharge after the battery's whole capacity has been consumed. If the battery does not serve the proper run time even after it has a full charge it may be at the end of it's useful life. Recharge / Discharge Number of Times: at least 500 (until rated capacity drops to 50%) Rubber ring BEFORE FIRST USE: The factory-loaded battery is not fully charged; the charge is useful only for a short period of time. Before first use, charge the battery fully following the instructions on [HOW TO CHARGE]. Bottle battery HOW TO ATTACH THE BRACKET on top of the bars Bracket (H-27) Rubber Pad Plug under the bars Rubber Pad Lamp Bracket (Use both of the two brackets for NC250) There are two ways of mounting the lamp unit to bicycle; on top of the bars or under the bars. Make sure no cables touch the lamp body. (If brake wire hinders the installation of the "mounting under the bars", use the optional extension spacer. ) 1. [. . . ] After leaving it for a while, the fuse will automatically recover. Note: If the fuse blows even after the malfunction is removed, or if the fuse does not recover, call the appropriate service center for assistance. Cord screw HOW TO MOUNT Bottle battery Mount the bottle battery into your bottle cage, the lamp body to the lamp bracket and the switch to the switch bracket. Connect the jack to the plug. SPECIFICATIONS 12W/20W Halogen Bulb (Only 12W Halogen Bulb with HL-NC260) Battery: Bottle battery /12V-2400mAH Ni-Cad Battery With thermal fuse for overcharge prevention Charger: CAT EYE Battery Charger (12V J6. 5 type) Operation Time: (when the temperature is 20°C) 12W: approx. 140 minutes of continuous use 20W: approx. [. . . ]