User manual CATEYE V2C QUICK START

[. . . ] Then use a paperclip to press the silver AC button for several seconds. Continue to hold the MENU button as the screen shows all available characters then stops at a screen with a large 24h on the top part of the screen. Select your preferred date format (YY/MM/DD) by pressing the M1/+ button (top right). [. . . ] Note: The data accumulated on a single ride can be zeroed out by pressing SSE and M2/simultaneously then releasing the buttons. Operation Test ­ to test for proper installation and function of the speed/ cadence sensor follow these steps: 1. After programming the computer head unit, start by pushing the M1/+ button once 2. Raise the rear wheel, spin, when numbers show up on the top row the speed sensor is operating normally 3. Turn the crank, when numbers show up in the middle section of the screen the cadence sensor is operating normally 4. If either the Speed or Cadence measurements fail to operate normally you will need to re-adjust the magnet position. You will need to adjust the magnet sensor position to get the magnet within 5mm or less from the sensor pickup zones. MENU ­ Additional features you may wish to modify after you have completed the head unit programming 1. FILE VIEW ­ to view file info press the silver MENU button on the back, then SSE to view file info, to scroll through lap data use the M1/+ and M2/2 buttons, when done press silver MENU button on back of computer NOTE: ride data must be 00 to make changes to cadence zone. To do this you must return to the main MENU then simultaneously press the SSE & M2/- buttons for several seconds then release 2. Cadence Zone ­ to setup cadence zone press the silver MENU button on the back, press M1/+ until you get to the CDC. ZONE screen, then SSE, then press M1/+, then SSE so that the lower number flashes, use the M1/+ and M2/- to select the lower cadence limit, when finished press SSE, use M1/+ and M2/- to select the upper cadence limit, SSE will toggle you though the zone numbers again in case you need to make any changes, press silver MENU button to confirm 3. Sound ­ to set sound press the silver MENU button, then press M1/+ until you get to the SOUND screen, then SSE, M1/+ will toggle the CDC. ALARM sound between On and Off, press SSE, M1/+ will toggle BUTTOn sound between On and Off. Count Down Distance ­ to enter a target trip distance for the countdown distance feature press the silver MENU button on the back, press M1/+ until you get to the C. D. DST screen, press SSE, use M1/+ and M2/- to choose far right digit, press SSE to index one digit to the left, M1/+ and M2/- to set next digit, SSE to scroll to the next digit, when complete press silver MENU button 5. Auto Mode ­ to switch between the auto and manual ride recording features­ press the silver MENU button, press the M1/+ until you get to the AUTO MODE screen. Press SSE, then press M1/+ to toggle between On and OFF, press silver MENU button to confirm 6. Odometer Input ­ to enter previous odometer miles press the silver MENU button, press the M1/+ until you get to the ODO INPUT screen. Press SSE to start entering an odometer number starting with the far right number first. Use the M1/+ and M2/- to toggle though each number, press SSE to move over to the next digit to the left. [. . . ] From here you can program the "B" tire size by pressing the M1/+ button while the "A" is flashing. After toggling to the "B" you will press SSE and follow the process above. Once complete press the silver MENU button 10. [. . . ]