User manual CDA RC9320

[. . . ] Twin cavity gas cookers RC 9320 . . GB Users Operating Instructions Installation instructions Before operating this cooker, please read these instructions carefully Dear Customer Thank you for choosing one of our appliances, carefully designed and built by our specialist staff and thoroughly tested to satisfy your cooking requirements. We suggest that you read this Instruction Booklet so that you will understand fully how to operate your appliance. You may wish to refer to it at a later date. CDA Important: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. [. . . ] You are advised to use a soft cloth and neutral soap. CAUTION: Do not use abrasive substances or non-neutral detergents as these will irreparably damage the surface. Changing the oven light 1. Disconnect the electrical power supply (for example, by switching off the main power switch). Note: Use only bulbs designed to resist up to 300°C with the following characteristics: 230 V, type E14 and same power (check watt power as stamped in the bulb itself) of the replaced bulb. 23 Burners They can be removed and washed only with soapy water. Detergents can be used but must not be abrasive or corrosive. After each cleaning, make sure that the burner-caps, as well as the burners, have been well wiped off and CORRECTLY POSITIONED. It is essential to check that the burner flame distributor F and the cap C has been correctly positioned (see fig. 25) - failure to do so can cause serious problems. Check that the electrode "S" (fig. 25) is always clean to ensure trouble-free sparking. C F S Fig. 25 Note: The electrode "S" must be very carefully cleaned. To avoid damage to the electric ignition do not use it when the burners are not in place. Triple ring burner The triple ring burner must be correctly positioned (see figs. 26-27); the burner rib must be located correctly in the burner base as shown by the arrow. The burner correctly positioned must not rotate (fig. Then position the cap A and the ring B (fig. 27 24 Removal of the inner glass door panel ­ The inner glass door panel can easily be removed for cleaning by unscrewing the fixing screws (fig. 28). ­ When re-assembly ensure that the inner glass is correctly positioned and do not over tighten the screws. Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass. Fig. 28 Storage compartment ­ The storage compartment is accessible through the pivoting panel. Attention: Do not store flammable material in the oven, or the storage compartment. Fig. 29 25 Inside of oven The oven should always be cleaned after use when it has cooled down. The cavity should be cleaned using a mild detergent solution and warm water. Suitable proprietary chemical cleaners may be used after first consulting with the manufacturers recommendations and testing a small sample of the oven cavity. Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface. [. . . ] Please help us to help you by having the following information available when booking a service-call: 1. Model type, make and model ­ see the product data plate. Evidence of installation / purchase date 3. Retailer where appliance was purchased 4. [. . . ]