User manual CDA RV700

[. . . ] Dual fuel cooker RV 700 . . GB Users Operating Instructions Installation instructions Before operating this cooker, please read these instructions carefully Dear Customer Thank you for choosing one of our appliances, carefully designed and built by our specialist staff and thoroughly tested to satisfy your cooking requirements. We suggest that you read this Instruction Booklet so that you will understand fully how to operate your appliance. You may wish to refer to it at a later date. CDA Important: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. [. . . ] Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner. IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abrasion. You are advised to use a soft cloth and neutral soap. CAUTION: Do not use abrasive substances or non-neutral detergents as these will irreparably damage the surface. Glass control panel Clean using an appropriate product. Do not use harsh abrasive cleaners or sharp metal scrapers to clean the control panel since they can scratch the surface, which may result in shattering of the glass. 23 Burners They can be removed and washed with soapy water only. They will remain always perfect if cleaned with products used for silverware. After cleaning or wash, check that burner-caps and burner-heads are dry before placing them in the respective housings. Note: To avoid damage to the electric ignition do not use it when the burners are not in place. Correct replacement of the burners It is very important to check that the burner flame distributor F and the cap C has been correctly positioned (see figs. 12-13) - failure to do so can cause a poor burner flame and/or damage to the burner and hob. Check that the electrode "S" (fig. 12) is always clean to ensure trouble-free sparking. The ignition plug must be very carefully cleaned. The burners become very hot during operation. Keep children away. C F S Fig. 13 24 Triple ring burner The triple ring burner must be correctly positioned (see fig. 16); the burner rib must be enter in their logement as shown by the arrow (see fig. Then position the cap A and the ring B (figs. The burner correctly positioned must not rotate (fig. 16 25 Assembling and dismantling of the side runner frames ­ Assemble the wire racks to the oven walls using the 2 screws (Figs. ­ Slide the tray and rack into the runners (Figs. The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven. ­ To dismantle, operate in reverse order. TOP OVEN BOTTOM MAIN OVEN Fig. 18b 26 Inside of oven The oven should always be cleaned after use when it has cooled down. [. . . ] Please help us to help you by having the following information available when booking a service-call: 1. Model type, make and model ­ see the product data plate. Evidence of installation / purchase date 3. Retailer where appliance was purchased 4. [. . . ]