User manual CDA TL1

[. . . ] This is provided that the mixer has been used for normal domestic purposes in the UK and that the care, installation and maintenance instructions have been observed. The warranty extends to the original purchaser only. You should retain a copy of your dated invoice as proof of purchase to validate any claims under this guarantee. [. . . ] We do not accept responsibility for problems that may occur through improper installation. Whilst assembling the tap take care not to accidentally loosen any screwed assemblies. Installation Preparation: Before installing the new mixer it is essential that you thoroughly flush through the supply pipes in order to remove any remaining solder, swarf or impurities from your system. Failure to carry out this simple procedure could cause problems or damage to the workings of the mixertap. We strongly recommend installing particle filter strainers and isolation valves to both the hot and cold feed pipes in an accessible position. This will help to prevent premature failure of the valves and ease any future maintenance. All parts should be removed from their packaging and inspected for any transport damage prior to installation. Shut off your water heating system and ensure that your mains stopcock is closed. Open the lowest hot and cold taps in the house and allow the water to run until the cold-water storage tank and pipes are fully empty. Please note, the hot water storage cylinder (if applicable) will always remain full. This mixertap requires a 35mm tap hole, if replacing an existing tap, remove the tap & clean the end of the feed pipes using wire wool the tap hole area should be free from dirt and sealant. Loosely position the tap and tail pipes to check if any alteration to the existing pipework is required, if this is the case do this now. Installation: 1. Pass the upper seal (B) over all wires and pipes onto the base of the tap (A). Pass the threaded section of the mixertap base (A), all wires and pipes through the taphole. Pass the lower washer (E), metal washer (F), and white triangular stabiliser (G) (if fitting to a stainless steel sink) over all wires, pipes and the threaded section of the mixertap base (A). Pass the fixing nut (H) over all wires and pipes onto the threaded section base of the tap (A). With the tap correctly located tighten the fixing nut fully. Screw the hot flexible tail pipe (I) into the hot inlet pipe (C). [. . . ] The light will only activate at a flow rate above 1 litre / minute. Key: A B C D E F G H I J K L M N O BB CC DD Description: Mixertap body Upper seal Hot water inlet pipe Cold water inlet pipe Lower washer Metal washer White triangular stabilizer (use only if installing tap to stainless steel sink) Fixing nut Hot flexible tail pipe Mixed water in flexible pipe Rubber washer Brass sensor Rubber washer Mixed water out flexible pipe Cold flexible tail pipe Mains Transformer black wire, yellow tag Grey wire, red tag Black wire, green tag Qty 1 1 1 1 1 1 1 BC 1 1 1 1 1 1 1 1 1 C PD After installation: Once you have visually checked the new fittings and connections, ensure that all taps are closed except the new mixer tap, which should be left open. Turn on the water supply at the mains stop cock. As the system starts to refill, check carefully for leaks. [. . . ]