User manual CHAMBERLAIN 975

[. . . ] Open your garage door and park your vehicle outside of the garage. Determine the mounting location on or near the ceiling and fasten the parking assist using the screw and anchor provided (Figure 1). [. . . ] NEVER look directly into the laser beam. Use of controls or adjustments, or the performance or procedures other than specified can result in hazardous radiation exposure. NOTE: Periodic adjustment of the beam may be required from time to time and is to be used only with the vehicle used during the initial setup. Open the garage door by activating the automatic garage door opener and drive your vehicle into parking space. The red beam can be seen moving across the hood of your vehicle as you drive further into the garage (Figure 6). Stop the vehicle when the beam is positioned at the location you confirmed in step 3 during the Set Up and Adjustment (Figure 7). nOTE: The beam will automatically deactivate after approximately 1 minute for Chamberlain/LiftMaster garage door opener installations. A residual reflection of the red beam from the windshield may appear on the walls or objects in your garage. When operating a vehicle, always ensure that there are no objects on the floor of the garage or in the path of your vehicle. This parking assist is not a substitute for safe parking practices. Drive your vehicle into the garage and park in the location you want to park your vehicle each time (Figure 5). Activate the parking assist locator by obstructing the path of the safety reversing sensors. the laser will emit a pulsing bright red beam. Using the swivel mount, aim the red beam to a location on the dash or hood that can easily be seen while seated in the driver's seat. [. . . ] Obstruct the path of the safety reversing sensors and look for the red spot on the garage floor. Please refer to your Liftmaster owner's manual for additional information on your garage door opener and the safety sensors. [. . . ]