User manual CHAMBERLAIN TM20

[. . . ] Watch the moving shutter or awning and keep away until the shutter has completely stopped. Ensure that the motor is accessible at all times following installation. A Carton Contents (1) TM10, TM20, TM30 or TM50 Tubular Motor (2) Screw M5x15 with washer (1 each) TM20, TM30, TM50 Screw 4. 8x22 with washer (1 each) ­ TM10 (3) Tube Adapter Set, 60mm octagonal TM20, TM30, TM50 (4) Tube Adapter Set, 40mm octagonal TM10 (5) Square tube bracket (1) or alternatively (5. 1) square tube pin (1) and 2 screws (6) Mounting bracket (1) (7) (8) (9) Cotter pin (1) Screw 3, 9 x 6, 5 (3) TM20, TM30, TM50 to armoured bracket Motor bracket TM10 (2 parts) (10) Mounting screws (2) TM10 for Motor bracket (11) adjuster pin Before You Begin: 1. Carefully read all the information contained in this Owner's Manual before beginning installation procedures. Check the shutter to be sure it is not broken or damaged, and that it opens and closes smoothly. [. . . ] B Push the tube adapter (3/4) onto the motor (1), and secure the drive adapter with the fixing parts (2) supplied. Insert the square tube bracket (5) into the recess in the motor head, and apply gentle pressure until it engages. If a square tube pin (5. 1) has been supplied, secure this with the screws. On model TM10, the motor bracket (9) is secured by means of 2 motor bracket mounting screws (10). Remove the shutter material from the tube (b). Remove the manual control (c). J SETTING THE LIMITS Procedure for Adjusting "Open" and "Cose" Positions (refer to figure I for lefthanded installation) #1 Limit Setting for "Shutter Open" + = increase closing travel ­ = decrease closing travel D Remove the tube. E switch operates only if the drive unit is fully inserted. Push the motor (1) completely into the tube. The limit #2 Limit Setting for "Shutter Close" + = increase opening travel ­ = decrease opening travel Ensure that the adapter ring is pushed fully home. Do not damage the tubular motor by drilling!F Proceed according to the specific requirements for leftsided (a) or right-sided (b) operation: Secure the mounting bracket (6) to the wall (10) (use G suitable screws and plugs). H Insert the square tube bracket on the motor (1) into the mounting bracket (6) and secure with the cotter pin (7). Make sure the set screws for the limit adjustments (beneath the mounting bracket) are accessible. Don't return the shutter material to the tube yet! Please observe that the limitis of the motor only operate in a complete installation. Read the following instructions carefully before making any open or close limit adjustments. To attach the shutter material on the tube, use ONLY the 3. 9 x 6. 5 mounting screws included (TM20, TM30, TM50). Otherwise, the drive might be damaged by screws which are too long. This instruction applies particularly to model TM10 (no screws included). Use the appropriate fixing parts to secure the shutter material to the tube. The drive may be damaged by using screws which are too long. IF ADJUSTMENTS ARE NEEDED, PROCEED AS FOLLOWS: LIMIT ADJUSTMENT SCREW #1 - OPEN Run the motor through an open cycle. [. . . ] Turn set screw #2 toward ­ and close shutter again. Repeat this step as often as necessary to reach the desired position. GB-2 Technical Data Motor does not run · Public electricity supply failure. · Circuit breaker has tripped or fuse is blown. If necessary, have an authorized electrician redistribute the load. [. . . ]