User manual CHAMBERLAIN TX2225

[. . . ] When electrical or electronic systems and appliances are in operation, certain components are live, which can constitute a risk. Any touching of and work performed on the equipment by persons not qualified to do so or non-compliance with safety instructions can result in personal injury or damage to property. Installation You can easily control your roller shutters with the TX2225 time switch from Chamberlain. [. . . ] While setting the hours and minutes, you can scroll through the values more quickly if you press and hold the UP or DOWN buttons: the figures will be increased or decreased respectively in steps of 5. You may exit the programming mode at any time by pressing and holding the STOP (MODE) button for at least 2 seconds. Automatic operation: After this operating mode is selected, the timer sends UP and DOWN commands at the specified times, every single day of the week. it is still possible to submit manual commands in this mode (see paragraph "Manual operation"). Manual operation: In this operating mode, it is possible to submit UP, STOP and DOWN commands simply by pressing the corresponding buttons (UP, STOP (MODE) and DOWN) in accordance with the following logic: if an Up or Down command has already been transmitted to the control unit on which the Timer codes have already been stored (see paragraph "Programming codes on a control unit") and the control unit motor time has not yet elapsed, any further Up, Stop or Down command will cause the motor to stop running. Holiday mode: In this operating mode, the scheduled daily automatic UP or DOWN commands are transmitted at a random period of 1 to 31 minutes before the set times. PROGRAMMING THE TX2225 TO THE CHAMBERLAIN RADIO CONTROLLED TUBULAR MOTOR RANGE To store the timer codes in the memory of electronic control units for sun blinds and rolling shutters, the control unit itself must be programmed accordingly: enter the radio control programming procedure (see relevant instruction manual) and press the UP button on the timer. When the control unit confirms that the procedure has been completed successfully, press any button on the timer: all three buttons (UP, STOP and DOWN) will now have been automatically stored in the memory of the control unit. Press any button of the TX2225 (stay within radio range of drive) · Re-connect power supply and wait · If it has worked, the drive turns 2x briefly as a signal that the command has been understood. F motor Note: The shutter should not be located at its limit. The drive turns 2x briefly as a signal indicating that the command has been understood (approx. ⷠThen press the UP button (upper button) and also the DOWN button (lower button) immediately and briefly. Once again the drive moves 2x briefly as a signal that the command has been understood. ⷠImmediately press any button of the TX2225. [. . . ] Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or product. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. [. . . ]