User manual CHAMBERLAIN WTMLS1

[. . . ] Installation and wiring must be in compliance with your local building and electrical codes. Do not allow children to play with fixed controls. Keep remote controls away from children. ) should be done before the final installation of the transmitter. [. . . ] Activation of the glass breakage sensor function: Press the two knobs on the sensor simultaneously until the LED briefly lights up in red. Hold down both knobs until the LED lights up in red for a second time after about 4 seconds. the glass breakage sensor function is now activated. If the sensor reacts too sensitively against slight vibrations turn the device about its axis to reduce the sensitivity. Press the two knobs on the sensor simultaneously until the LED briefly lights up in red. Hold down both knobs for about 4 seconds until the LED lights up in green. Turn the sensor by one to two degrees if it reacts too sensitively (glass breakage function). During programming the distance between the sensor and timer should be no more than 5 metres. Ensure that you are firmly holding down the two knobs as required as well as simultaneously. Has the timer/receiver been correctly connected and is there a power supply?Don't forget to always confirm your menu selection on the TCTRX2ED with the UP key. Declaration of Incorporation The Light and Glass Breakage Sensor Model TCLS1ED, when installed and maintained according to all the Manufacturer's instructions in combination with a shutter, which has also been installed and maintained according to all the Manufacturer's instructions, meet the provisions of EU Directive 89/392/EEC and all amendments. I, the undersigned, hereby declare that the equipment specified above and any accessory listed in the manual conforms to the above Directives and Standards. These safety alert symbols mean Caution - a personal safety or property damage instruction. Failure to comply with the following instructions may result in serious personal injury or property damage. Installation and wiring must be in compliance with your local building and electrical codes. Do not allow children to play with fixed controls. Keep remote controls away from children. Pull the module out of its frame and plug the coupling into the socket on the bottom edge under the TCT2ED display. Close the roller shutter manually until the desired shading effect has been achieved. Press the suction bell onto the inside of the window pane. The level of light after which the roller shutters should close (set value), is shown as a small dot in the upper right corner of the bar. [. . . ] Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects. Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be defective and does not cover the costs or risks of transportation of the defective parts or product. This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain GmbHs instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain GmbH's option) at no cost to the owner for the repair and/or replacement parts and/or product. [. . . ]