User manual CHANEY INSTRUMENT MODEL 00804 WIRELESS THERMOMETER WITH HUMIDITY, CLOCK AND REMOTE SENSOR

[. . . ] ALARM Read Alarm time, turn off alarm Enter Alarm Set setting sequence: Hr > Min > confirm & exit Read maximum/ minimum records (the memory will automatically clear every day at midnight) A MIN/ MAX EF CHANNEL Select Channel 1, 2, 3 Clear current channel SNOOZE / LIGHT: Press to activate the Snooze function and to illuminate the backlight for 3 seconds G BATTERY INSTALLATION Home Receiver: Lift off the battery cover at the back and install 2 fresh "AA" alkaline batteries according to the polarity indicated. Remote Sensor: Lift off the bracket stand, loosen the 4 screws with a small screwdriver, insert 2 fresh "AAA" alkaline batteries according to the polarity indicated. Replace the cover and tighten the 4 screws. Batteries are not included. B C D SETTING UP THE WIRELESS THERMOMETER: · A = Snooze/Light Button B = Channel Button C = Alarm Button D = Min/Max Button E = Set/ F = +/ G = -/ C/F(ZONE) · · Always insert batteries to the home unit and then the remote sensor. Press the CHANNEL button to Ch 1 for the first sensor. [. . . ] The tower icon in the left hand corner of the screen appears fixed when reception is successful. To turn the reception off and to enable manual settings, press the "­" button. ALARM STOP Press the ALARM button to stop the alarm for 24 hours. The alarm can also be silenced by pressing the "+" button on the back of the unit wit the bell symbol over it. This will turn off the alarm until you press this button again to reactivate it. Radio Controlled (R/C) Time Reception Set Up: The clock attempts to synchronize with SNOOZE / LIGHT Press to enter the SNOOZE mode. The alarm will sound again in 8 minutes. A green backlight will also illuminate for 3 seconds each time this button is pressed. MIN/ MAX MEMORY Press the "MIN/ MAX" to view the maximum temperature & humidity values for both indoors & outdoors. After 5 seconds the display will return to the present readings. The memory will be cleared every night at midnight. Entering the Time Zone: After establishing your time signal, press SET/ ZONE once to select TEMPERATURE & HUMIDITY TRENDS (Outdoor Temp & Humidity) PST/ MST/ CST or EST time zones. A small P, M, C, E icon will appear to the left of the time display for the respective time zone. P = Pacific Standard Time M = Mountain Standard Time C = Central Standard Time E = Eastern Standard Time If the Temperature increases more then 1 degree or the Humidity increase by 3% the Trend arrow will point UP showing a rising trend. If the Temperature change is less than 1 degree or the Humidity changes less than 3% the Trend arrow will be level showing a steady reading. If the Temperature drops more than 1 degree or the Humidity drops 3% the Trend Arrow will point DOWN showing an falling trend. Trend icons update every hour. How to Manually Synchronize Your Atomic Clock: Hold the "­" button for 4 second to trigger a manual synchronization. The tower will flash regularly during synchronization. Signal strength level is indicated in this way: 1. Icon appears fixed and does not blink(Reception successful) 5. Icon does not show (No signal received) If signal level is weak and time reception is not successful, move the unit away any source of possible interference and try again in another location. The R/C clock will attempt a daily synchronization at 1:00 AM everyday. If not successful, the R/C clock will search for the time signal every hour. Each R/C reception cycle lasts from 2 minutes to 5 minutes. [. . . ] Set the required hour by pressing the "+" or "­" buttons on the back of the unit. Be sure to pay attention to the proper AM or PM setting to ensure your alarm will sound at the correct time. Press the Alarm button again and the minutes will flash. Set to the correct time usint he "+" and "­" buttons on the back of the unit. [. . . ]