User manual CHICAGO 94862

[. . . ] There are certain applications for which this product was designed. It will do the job better and more safely at the rate for which it was intended. Do not modify this product and do not use for a purpose for which it was not intended. Do not wear loose clothing or jewelry as they can be caught in moving parts. [. . . ] Read warning labels if taking prescription medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate this product. 8. 9. Note: Performance of this tool may vary depending on variations in battery power. Product Specific Safety Precautions Warning: The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety Code 25249. 5 et seq. ) 1. During installation, remove ignition keys from the vehicle and set the parking brake. Only connect the positive (+) hot lead to a fused terminal or circuit. Do not wear rings, watches, or other metallic objects around your hands and arms. 2. 3. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Warning: People with pacemakers should consult their physician(s) before using this product. Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker. Unpacking When unpacking, check to make sure the following parts are included. Refer to the Parts List and Parts Photo at the end of this manual. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual. SKU 94862 For technical questions, please call 1-800-444-3353 Page 3 Installation Caution: If you are not familiar with working around vehicle engine compartments, the installation should be completed by a qualified technician. Before attempting installation of the Air Horns, remove the keys from the vehicle ignition, set the emergency brake, and place wheel chocks. Lift the vehicle hood and find a suitable location to mount the Horns and Compressor. This location must shelter the Compressor (4) and Horns (1, 2, and 3) from incoming rain, road water, and mud from under the vehicle. It also must be away from all moving engine parts and heat. Using a Bolt and Nut (9), mount the Compressor (4) to the vehicle chassis in a vertical position (air outlets facing up). A hole may need to be drilled in the chassis frame to accomplish this. Always be careful that no electrical wires or cables are in the drilling path. [. . . ] If the Compressor turns on and the Horns do not sound, reverse the Compressor connections (+ / -). The Air Horns will now sound when the vehicle horn is pushed. Maintenance 1. Periodically add a few drops of light oil to each air outlet of the Compressor. Wear ANSI approved safety glasses for this process. [. . . ]