User manual CHICAGO 95987

[. . . ] Keep this manual and invoice in a safe and dry place for future reference. GeneRAl And SPecific SAfety RUleS wARninG!ReAd And UndeRStAnd All inStRUctionS failure to follow all instructions listed below may result in serious injury. SAVe theSe inStRUctionS woRk AReA 1. Cluttered benches and dark areas invite accidents. [. . . ] Use only accessories that are recommended by the manufacturer for your Bearing Puller. Accessories that may be suitable for one tool may become hazardous when used on another tool. Make sure the engine you are working on is secure. If the engine is away from the vehicle, make sure it is securely stabilized before you begin to work. Maintain labels and nameplates on the tool. If unreadable or missing, contact Harbor Freight Tools for a replacement. Make sure there is adequate surrounding workspace. Keep fingers and hands out of the path of the Slide Hammer. when servicing a tool, use only identical replacement parts. follow instructions in the "Inspection, Maintenance, And Cleaning" section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of injury. SKU 95987 for technical questions, please call 1-800-444-3353. Page 3 UnPAckinG When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. ASSeMBly inStRUctionS note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on page 8 of this manual. note: This Bearing Puller comes mostly assembled. The only additional assembly needed is threading one of the four Attachments onto the end the Slide Hammer. See figure 1 oPeRAtion inStRUctionS 1. After threading the proper Attachment (3, 4, 5 or 6) onto the end of the Slide Hammer (1) make sure the clamps of the Attachment are completely closed. note: To open or close the Attachment Clamps, grasp the Attachment head firmly and twist the Handle (2) of the Slide Hammer (1). Clockwise motion will open the clamps, while counterclockwise motion will close them. SKU 95987 for technical questions, please call 1-800-444-3353. Page 4 2. 4. Insert the Attachment head into the inner diameter of the bearing as shown in figure 2 Grasp the Attachment head while turning the Handle (2) clockwise until the Attachment clamps open and are are snug against the bearing lining. Firmly grasp the Slide Hammer (1) and Handle (2) with hands. Spread feet shoulder width apart. Figure 3 5. 6. Gently push Slide Hammer (1) forward. Make sure your fingers are not in the way of the sliding action and weAR GloVeS. See figure 3 Forcefully pull Slide Hammer (1) backward towards your body. [. . . ] Check for loose attachments, binding of moving parts, cracked or broken Attachments, and any other condition that may affect its safe operation. If any abnormality is found, have the problem corrected before further use. do not use damaged equipment. MAintenAnce chARt Maintenance type Inspect tool for damage (see paragraph above) Wipe off with clean, moist cloth Before Use After Use weekly Monthly every 6 Months yearly X X X tRoUBleShootinG Problem Selected Attachment does not open or close smoothly Possible causes Probable Solutions 1. Carefully remove Attachment and inspect threads for damage 2. [. . . ]