User manual CHICAGO 96349

[. . . ] Protect others in the work area from debris such as chips and sparks. Store idle products out of reach of children and other untrained persons. Never allow children to play with or around the Wheel Chock. 2. note: The Wheel Chock will fit most standard motorcycles currently on the market. especially wide tires or custom lowprofile front fenders will not fit into the Wheel Chock. Save this Manual You will need this manual for 1. [. . . ] Maintain labels and nameplates on the tool. If unreadable or missing, contact Harbor Freight Tools for a replacement. Make sure there is adequate surrounding workspace. Do not use this product in a damp or wet location. use the correct product for your motorcycle. Make sure the motorcycle's wheel fits into the Wheel Chock prior to first use. being secured. Be certain that the location will not obstruct walkways and will still provide enough room to retrieve the motorcycle after it is mounted. The surface of the location should be one suitable for the mounting of heavy equipment. Use the mounting holes in the Base (7) of the Wheel Chock as a template. Arrange the Base (7) in the chosen location and, using a pencil, mark where the holes are to be drilled. You will need concrete anchors (not included) to secure the Base (7) to the concrete floor. Using the correct size concrete drill bit (not included), drill the mounting holes to secure the Base (7). Attache the concrete anchors to the floor. Secure the Base (7) to the floor utilizing the concrete anchors. 6. 7. unpAcking When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. truck Bed or Motorcycle lift Mounting 1. Place the Base (7) in the desired location of the truck bed or motorcycle lift that you want to mount it at. Use the of the Base (7) as a pattern to mark where you will drill the holes that accept the hardware to mount the Wheel Chock. Use a power drill (not included) and a steel cutting drill bit (not included) to drill holes in the truck bed or motorcycle lift. ASSeMBly And inStAllAtion inStructionS note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram at the end of the manual. The Wheel Chock comes fully assembled, however it must be mounted onto a solid surface to secure it. It is designed to be mounted on the bed of a truck, or a motorcycle lift, or onto a concrete floor. warning: Verify that the installation surface has no hidden wires, brake lines, etc. Attach the Base (7) to the truck bed utilizing the Mounting Bolts (6), Nylon Sleeves (8), Large Washers (9), Spring Washers (3), and secure with Hex Nuts (10). See page 6, assembly diagram. concrete Floor Mounting 1. [. . . ] Occasionally, wipe the Wheel Chock down with a soft cloth and mild detergent. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise. If our inspection verifies the defect, we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will return repaired products at our expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our warranty, then you must bear the cost of returning the product. [. . . ]