User manual CHICAGO 98800

[. . . ] No portion of this document or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this document may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included. For technical questions or replacement parts, please call 1-800-444-3353. at the number shown on the cover of this document as soon as possible. Important saFetY InFormatIon assembly precautions 1. [. . . ] Inspect before use; do not use if parts are loose or damaged. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement. 6. 7. Rotate the rear wheel by hand while cleaning, polishing or maintaining the chain. Make certain to keep the rear wheel in the center of the Wheel Cleaning Stand. If the wheel should slide to the side of the Stand, move it back into the center. For front wheel cleaning, repeat steps 1 through 7 as above, but placing the Cleaning Stand ahead of the front wheel. 10. Before each use, inspect the general condition of the Wheel Cleaning Stand. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, and any other condition that may affect its safe operation. After each use, clean the Wheel Cleaning Stand with a soft, dry towel. Do not use harsh chemicals or solvents to clean the Stand. Do not use abrasives or abrasive materials to clean the Stand as this will damage its protective finish. Periodically lube contact points and Rollers with grease. 2. 3. assemblY InstructIons read the entIre Important saFetY InFormatIon section at the beginning of this document including all text under subheadings therein before set up or use of this product. 4. operatIng InstructIons 1. Place the Wheel Cleaning Stand on a flat and level area capable of supporting the Wheel Cleaning Stand and the vehicle being cleaned. Place the Cleaning Stand behind the rear wheel. Wheel must be at a right angle to the direction of the wheel to be cleaned. Manually roll the motorcycle up the Ramp (9) and onto the Wheel Cleaning Stand. Make certain that the rear motorcycle wheel has rolled over the first roller and sits between both Rollers (8). Allow the rear wheel to fully rest between Rollers (8). [. . . ] To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise. If our inspection verifies the defect, we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will return repaired products at our expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our warranty, then you must bear the cost of returning the product. [. . . ]