User manual CHICCO ELETTA

[. . . ] Com 5 GB Instructions for use VERY IMPORTANT: TO BE READ IMMEDIATELY • lease follow carefully these instructions on how to assemble and fit the product. The product must not be used by anybody who has not read these instructions. € Keep this instruction booklet for future use. € Each country has different safety laws and regulations for the transportation of children in cars. [. . . ] This child restraint has been classified as “Universal” under more stringent conditions than those that were applied to earlier designs not displaying this notice. Only suitable if the vehicle is fitted with a 3-point static or 3-point retractor safety belt approved to UN/ECE Regulation No. If in doubt, consult either the child restraint manufacturer or the retailer. pRODUCT AND CAR SEAT USE RESTRICTIONS AND REQUIREMENTS WARNING!Please read carefully the following product and car seat use restrictions and requirements. Failure to comply with these instructions may affect the safety of your child. € This Child Car Seat is approved for use only for children between 0 and 18 kg of weight (from birth up to 3 years of age, approximately). € The car seat must be fitted with a 3-point static or 3-point retractor safety belt, approved to UNI/ECE No. Never fit the Child Car Seat to a seat that is only equipped with a 2-point safety belt (Diag. € The Child Car Seat may be fitted into the front passenger seat or any rear seat. Never use this Child Car Seat on side-facing or rear-facing car seats (Diag. € This product is expressly intended to be used only as a Child Car Seat; it should not be used indoors. hOW TO FIT THE CHILD CAR SEAT INTO THE CAR FOR GROUP 0+ (From 0 up to 13 kg) WARNING!When it is used for Group 0+ (from 0 up to 13 kg), always fit the Child Car Seat in a rearward-facing direction. If the front seat of the car is equipped with an airbag, deactivate the airbag before fitting the Child Car Seat. The points through which the safety belt must pass for fitting for Group 0+ (from 0 up to 13 kg) are highlighted in LIGHT BLUE. Never use the insert pillow if the child weighs over 6 kg. 6 – Adjust the Child Car Seat to the most reclined position with the handle K. 7 – Position the Child Car Seat on the car seat in a rearward-facing position. 9 – Tension the lap section of the belt as much as possible, and insert it inside the appropriate guide 7 O, located on the same side where you are fitting the Child Car Seat. 10 – Check that the Child Car Seat is tightly and correctly fitted into the car seat, and that the safety belt is well tensioned. If the Child Car Seat is not tightly and safely fitted into the car seat, repeat the installation. [. . . ] 23 – Pull the harness straps from the front to remove them from the backrest and shoulder straps. 24 – Remove the shoulder straps, turning and removing the locking plates from the respective holes on the backrest. 25 – Reinsert the plates of the shoulder straps at the desired height, inside the respective holes on the backrest. 26 – Lock the two tabs into the buckle. [. . . ]