User manual CIPHERLAB 8001

[. . . ] Due to continued product development this information may change without notice. The information and intellectual property contained herein is confidential between CIPHERLAB and the client and remains the exclusive property of CIPHERLAB CO. If you find any problems in the documentation, please report them to us in writing. CIPHERLAB does not warrant that this document is error-free. [. . . ] Then, it will try to connect to the server. Note: After the “PPP via IR” connection is established properly, run the utility “Echo Test” on your computer (TCP/IP – Server), and then, start this test on your mobile computer. You must configure these parameters correctly. Information DHCP I M G DHCP server in use or not IP address of the mobile computer Subnet Mask Default Gateway Note: For Transparent mode, refer to Serial PPP Menu for available libraries. Enter a new address for the mobile computer, if necessary. Enter a new address for the default Gateway, if necessary. Enter a new address for the DNS server, if necessary. The domain name of the host is shown here when DHCP server is enabled. Note: Normally, DHCP is enabled and all of the settings can be obtained form the DHCP server. Chapter 4 Configuration 41 IR Network Menu > Echo Tests The Ethernet Cradle supports three working modes: Data Mode Modem Mode Transparent Mode These echo tests are used for verifying connectivity via the Ethernet Cradle. For details, refer to the Ethernet Cradle manual. Enter the IP address of a server with which a connection is desired. Server Mode - Set the mobile computer as a server that waits for other devices to connect to. Note: After the “Ethernet via IR” connection is established properly, run the utility “Echo Test” on your computer (TCP/IP – Server or Client), and then, start this test on your mobile computer. 7 (3) Bluetooth Menu – for 8061 This submenu is for the Bluetooth module to work with other Bluetooth enabled devices. You must configure these parameters correctly. Note: This submenu is generated only when the Bluetooth module is present. Information LIB MAC ID C library version for Bluetooth (BNEP) MAC ID of the Bluetooth module A name given to the mobile computer for identification. Local Name) CTY "Normal" means all 79 channels are available for frequency-hopping (There are bandwidth limitations for 2. For example, only 23 RF channels are defined instead of 79 RF channels in Japan, Spain and France. ) DHCP IP Mask Gate DHCP server in use or not IP address of the mobile computer Subnet Mask Default Gateway 44 8000 Series Reference Manual Bluetooth Menu > Connect Setting A basic Bluetooth system can be configured as (1) point to point - DUN mode, and (2) point to multi-point - SPP or PAN mode. Remote Name Enter a name for identifying the mobile computer. [. . . ] DO NOT remove the mobile computer or disconnect the cradle before communications are done. If the problem persists, run the IR Echo Test to check the IR interface between the mobile computer and the cradle. 3) 75 Over MODEM port via cradle Check if the modem connection is correct and secured. Make sure the modem parameters are configured to match the parameters on the mobile computer. [. . . ]